From 94d2adc9c0b24863ccce467b280ac95f2acb83b0 Mon Sep 17 00:00:00 2001 From: Jonathan Albrieux Date: Thu, 28 May 2020 16:59:28 +0200 Subject: [PATCH] dt-bindings: iio: magnetometer: ak8975: add gpio reset support Add reset-gpio support. Without reset's deassertion during ak8975_power_on(), driver's probe fails on ak8975_who_i_am() while checking for device identity for AK09911 chip. AK09911 has an active low reset gpio to handle register's reset. AK09911 datasheet says that, if not used, reset pin should be connected to VID. This patch emulates this situation. Signed-off-by: Jonathan Albrieux Reviewed-by: Rob Herring Signed-off-by: Jonathan Cameron --- .../bindings/iio/magnetometer/asahi-kasei,ak8975.yaml | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml b/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml index 1fc06a250017..f4393bfbf355 100644 --- a/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml +++ b/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml @@ -46,6 +46,11 @@ properties: mount-matrix: description: an optional 3x3 mounting rotation matrix. + reset-gpios: + description: | + an optional pin needed for AK09911 to set the reset state. This should + be usually active low + required: - compatible - reg @@ -53,6 +58,7 @@ required: examples: - | #include + #include i2c { #address-cells = <1>; #size-cells = <0>; @@ -63,6 +69,7 @@ examples: interrupt-parent = <&gpio6>; interrupts = <15 IRQ_TYPE_EDGE_RISING>; vdd-supply = <&ldo_3v3_gnss>; + reset-gpios = <&msmgpio 111 GPIO_ACTIVE_LOW>; mount-matrix = "-0.984807753012208", /* x0 */ "0", /* y0 */ "-0.173648177666930", /* z0 */ -- 2.39.5