# This file tells the frr package which daemons to start. # # Entries are in the format: =(yes|no|priority) # 0, "no" = disabled # 1, "yes" = highest priority # 2 .. 10 = lower priorities # # For daemons which support multiple instances, a 2nd line listing # the instances can be added. Eg for ospfd: # ospfd=yes # ospfd_instances="1,2" # # Priorities were suggested by Dancer . # They're used to start the FRR daemons in more than one step # (for example start one or two at network initialization and the # rest later). The number of FRR daemons being small, priorities # must be between 1 and 9, inclusive (or the initscript has to be # changed). /etc/init.d/frr then can be started as # # /etc/init.d/frr > # # where priority 0 is the same as 'stop', priority 10 or 'start' # means 'start all' # # Sample configurations for these daemons can be found in # /usr/share/doc/frr/examples/. # # ATTENTION: # # When activation a daemon at the first time, a config file, even if it is # empty, has to be present *and* be owned by the user and group "frr", else # the daemon will not be started by /etc/init.d/frr. The permissions should # be u=rw,g=r,o=. # When using "vtysh" such a config file is also needed. It should be owned by # group "frrvty" and set to ug=rw,o= though. Check /etc/pam.d/frr, too. # watchfrr_enable=no watchfrr_options=("-b_" "-r/usr/lib/frr/frr_restart_%s" "-s/usr/lib/frr/frr_start_%s" "-k/usr/lib/frr/frr_stop_%s") # zebra=no bgpd=no ospfd=no ospf6d=no ripd=no ripngd=no isisd=no ldpd=no pimd=no nhrpd=no eigrpd=no babeld=no sharpd=no pbrd=no # # Command line options for the daemons # zebra_options=("-A 127.0.0.1") bgpd_options=("-A 127.0.0.1") ospfd_options=("-A 127.0.0.1") ospf6d_options=("-A ::1") ripd_options=("-A 127.0.0.1") ripngd_options=("-A ::1") isisd_options=("-A 127.0.0.1") ldpd_options=("-A 127.0.0.1") pimd_options=("-A 127.0.0.1") nhrpd_options=("-A 127.0.0.1") eigrpd_options=("-A 127.0.0.1") babeld_options=("-A 127.0.0.1") sharpd_options=("-A 127.0.0.1") pbrd_options=("-A 127.0.0.1") # # If the vtysh_enable is yes, then the unified config is read # and applied if it exists. If no unified frr.conf exists # then the per-daemon .conf files are used) # If vtysh_enable is no or non-existant, the frr.conf is ignored. # it is highly suggested to have this set to yes vtysh_enable=yes