use listings for file contents

[pve-docs.git] / local-zfs.adoc

diff --git a/local-zfs.adoc b/local-zfs.adoc
index fab009336b9b1bfb9667564505b0c88e07288456..9b682b9b09e51d1ebee2562d7054a57e98d719c0 100644 (file)
--- a/local-zfs.adoc
+++ b/local-zfs.adoc
@@ -158,7 +158,7 @@ GRUB boot loader there. If you use a redundant RAID setup, it installs
 the boot loader on all disk required for booting. So you can boot
 even if some disks fail.
 
 the boot loader on all disk required for booting. So you can boot
 even if some disks fail.
 

-NOTE: It is not possible to use ZFS as root partition with UEFI
+NOTE: It is not possible to use ZFS as root file system with UEFI

 boot.
 
 
 boot.
 
 


@@ -242,7 +242,7 @@ As `<device>` it is possible to use more devices, like it's shown in
 If you have an pool without cache and log. First partition the SSD in
 2 partition with `parted` or `gdisk`
 
 If you have an pool without cache and log. First partition the SSD in
 2 partition with `parted` or `gdisk`
 

-IMPORTANT: Always use GPT partition tables (gdisk or parted).
+IMPORTANT: Always use GPT partition tables.

 
 The maximum size of a log device should be about half the size of
 physical memory, so this is usually quite small. The rest of the SSD
 
 The maximum size of a log device should be about half the size of
 physical memory, so this is usually quite small. The rest of the SSD


@@ -265,7 +265,9 @@ pool errors.
 To activate the daemon it is necessary to edit `/etc/zfs/zed.d/zed.rc` with your
 favourite editor, and uncomment the `ZED_EMAIL_ADDR` setting:
 
 To activate the daemon it is necessary to edit `/etc/zfs/zed.d/zed.rc` with your
 favourite editor, and uncomment the `ZED_EMAIL_ADDR` setting:
 

+--------

 ZED_EMAIL_ADDR="root"
 ZED_EMAIL_ADDR="root"

+--------

 
 Please note {pve} forwards mails to `root` to the email address
 configured for the root user.
 
 Please note {pve} forwards mails to `root` to the email address
 configured for the root user.


@@ -312,7 +314,9 @@ run into low memory situations. Additionally, you can lower the
 To make the swappiness persistent, open `/etc/sysctl.conf` with
 an editor of your choice and add the following line:
 
 To make the swappiness persistent, open `/etc/sysctl.conf` with
 an editor of your choice and add the following line:
 

- vm.swappiness = 10
+--------
+vm.swappiness = 10
+--------

 
 .Linux kernel `swappiness` parameter values
 [width="100%",cols="<m,2d",options="header"]
 
 .Linux kernel `swappiness` parameter values
 [width="100%",cols="<m,2d",options="header"]