]>
Commit | Line | Data |
---|---|---|
d2912cb1 | 1 | // SPDX-License-Identifier: GPL-2.0-only |
73db9e01 TL |
2 | /dts-v1/; |
3 | ||
4 | #include "dm814x.dtsi" | |
0c3e192a | 5 | #include <dt-bindings/interrupt-controller/irq.h> |
73db9e01 TL |
6 | |
7 | / { | |
8 | model = "DM8148 EVM"; | |
647efef6 | 9 | compatible = "ti,dm8148-evm", "ti,dm8148", "ti,dm814"; |
73db9e01 | 10 | |
c5ee1b48 | 11 | memory@80000000 { |
73db9e01 TL |
12 | device_type = "memory"; |
13 | reg = <0x80000000 0x40000000>; /* 1 GB */ | |
14 | }; | |
67b5e9ec TL |
15 | |
16 | /* MIC94060YC6 controlled by SD1_POW pin */ | |
0b0d912a | 17 | vmmcsd_fixed: fixedregulator0 { |
67b5e9ec TL |
18 | compatible = "regulator-fixed"; |
19 | regulator-name = "vmmcsd_fixed"; | |
20 | regulator-min-microvolt = <3300000>; | |
21 | regulator-max-microvolt = <3300000>; | |
22 | }; | |
73db9e01 TL |
23 | }; |
24 | ||
25 | &cpsw_emac0 { | |
abf878dd | 26 | phy-handle = <ðphy0>; |
87ee15ec | 27 | phy-mode = "rgmii"; |
73db9e01 TL |
28 | }; |
29 | ||
30 | &cpsw_emac1 { | |
abf878dd | 31 | phy-handle = <ðphy1>; |
87ee15ec | 32 | phy-mode = "rgmii"; |
73db9e01 | 33 | }; |
67b5e9ec | 34 | |
abf878dd GS |
35 | &davinci_mdio { |
36 | ethphy0: ethernet-phy@0 { | |
37 | reg = <0>; | |
38 | }; | |
39 | ||
40 | ethphy1: ethernet-phy@1 { | |
41 | reg = <1>; | |
42 | }; | |
43 | }; | |
44 | ||
0589df6a TL |
45 | &gpmc { |
46 | ranges = <0 0 0x04000000 0x01000000>; /* CS0: 16MB for NAND */ | |
47 | ||
48 | nand@0,0 { | |
0c3e192a | 49 | compatible = "ti,omap2-nand"; |
0589df6a | 50 | reg = <0 0 4>; /* CS0, offset 0, IO size 4 */ |
0c3e192a RQ |
51 | interrupt-parent = <&gpmc>; |
52 | interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */ | |
53 | <1 IRQ_TYPE_NONE>; /* termcount */ | |
54 | linux,mtd-name= "micron,mt29f2g16aadwp"; | |
0589df6a TL |
55 | #address-cells = <1>; |
56 | #size-cells = <1>; | |
57 | ti,nand-ecc-opt = "bch8"; | |
58 | nand-bus-width = <16>; | |
59 | gpmc,device-width = <2>; | |
60 | gpmc,sync-clk-ps = <0>; | |
61 | gpmc,cs-on-ns = <0>; | |
62 | gpmc,cs-rd-off-ns = <44>; | |
63 | gpmc,cs-wr-off-ns = <44>; | |
64 | gpmc,adv-on-ns = <6>; | |
65 | gpmc,adv-rd-off-ns = <34>; | |
66 | gpmc,adv-wr-off-ns = <44>; | |
67 | gpmc,we-on-ns = <0>; | |
68 | gpmc,we-off-ns = <40>; | |
69 | gpmc,oe-on-ns = <0>; | |
70 | gpmc,oe-off-ns = <54>; | |
71 | gpmc,access-ns = <64>; | |
72 | gpmc,rd-cycle-ns = <82>; | |
73 | gpmc,wr-cycle-ns = <82>; | |
0589df6a TL |
74 | gpmc,bus-turnaround-ns = <0>; |
75 | gpmc,cycle2cycle-delay-ns = <0>; | |
76 | gpmc,clk-activation-ns = <0>; | |
0589df6a TL |
77 | gpmc,wr-access-ns = <40>; |
78 | gpmc,wr-data-mux-bus-ns = <0>; | |
79 | partition@0 { | |
80 | label = "X-Loader"; | |
81 | reg = <0 0x80000>; | |
82 | }; | |
83 | partition@0x80000 { | |
84 | label = "U-Boot"; | |
85 | reg = <0x80000 0x1c0000>; | |
86 | }; | |
87 | partition@0x1c0000 { | |
88 | label = "Environment"; | |
89 | reg = <0x240000 0x40000>; | |
90 | }; | |
91 | partition@0x280000 { | |
92 | label = "Kernel"; | |
93 | reg = <0x280000 0x500000>; | |
94 | }; | |
95 | partition@0x780000 { | |
96 | label = "Filesystem"; | |
97 | reg = <0x780000 0xf880000>; | |
98 | }; | |
99 | }; | |
100 | }; | |
101 | ||
1ddbef4d NC |
102 | &mmc1 { |
103 | status = "disabled"; | |
104 | }; | |
105 | ||
67b5e9ec TL |
106 | &mmc2 { |
107 | pinctrl-names = "default"; | |
108 | pinctrl-0 = <&sd1_pins>; | |
109 | vmmc-supply = <&vmmcsd_fixed>; | |
110 | bus-width = <4>; | |
111 | cd-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>; | |
112 | }; | |
113 | ||
1ddbef4d NC |
114 | &mmc3 { |
115 | status = "disabled"; | |
116 | }; | |
117 | ||
67b5e9ec TL |
118 | &pincntl { |
119 | sd1_pins: pinmux_sd1_pins { | |
120 | pinctrl-single,pins = < | |
121 | DM814X_IOPAD(0x0800, PIN_INPUT | 0x1) /* SD1_CLK */ | |
122 | DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP | 0x1) /* SD1_CMD */ | |
123 | DM814X_IOPAD(0x0808, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[0] */ | |
124 | DM814X_IOPAD(0x080c, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[1] */ | |
125 | DM814X_IOPAD(0x0810, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[2] */ | |
126 | DM814X_IOPAD(0x0814, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[3] */ | |
127 | DM814X_IOPAD(0x0924, PIN_OUTPUT | 0x40) /* SD1_POW */ | |
128 | DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP | 0x80) /* GP1[6] */ | |
129 | >; | |
130 | }; | |
e032013f TL |
131 | |
132 | usb0_pins: pinmux_usb0_pins { | |
133 | pinctrl-single,pins = < | |
134 | DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */ | |
135 | >; | |
136 | }; | |
137 | ||
138 | usb1_pins: pinmux_usb1_pins { | |
139 | pinctrl-single,pins = < | |
140 | DM814X_IOPAD(0x0834, PIN_OUTPUT | 0x80) /* USB1_DRVVBUS */ | |
141 | >; | |
142 | }; | |
143 | }; | |
144 | ||
145 | &usb0 { | |
146 | pinctrl-names = "default"; | |
147 | pinctrl-0 = <&usb0_pins>; | |
148 | dr_mode = "host"; | |
149 | }; | |
150 | ||
151 | &usb1 { | |
152 | pinctrl-names = "default"; | |
153 | pinctrl-0 = <&usb1_pins>; | |
154 | dr_mode = "host"; | |
67b5e9ec | 155 | }; |