]>
Commit | Line | Data |
---|---|---|
a900f516 TL |
1 | #include "omap2420.dtsi" |
2 | ||
3 | / { | |
4 | memory { | |
5 | device_type = "memory"; | |
6 | reg = <0x80000000 0x8000000>; /* 128 MB */ | |
7 | }; | |
8 | ||
9 | ocp { | |
10 | i2c@0 { | |
11 | compatible = "i2c-cbus-gpio"; | |
12 | gpios = <&gpio3 2 0 /* gpio66 clk */ | |
13 | &gpio3 1 0 /* gpio65 dat */ | |
14 | &gpio3 0 0 /* gpio64 sel */ | |
15 | >; | |
16 | #address-cells = <1>; | |
17 | #size-cells = <0>; | |
18 | retu_mfd: retu@1 { | |
19 | compatible = "retu-mfd"; | |
20 | interrupt-parent = <&gpio4>; | |
21 | interrupts = <12 IRQ_TYPE_EDGE_RISING>; | |
22 | reg = <0x1>; | |
23 | }; | |
24 | }; | |
25 | }; | |
26 | }; | |
27 | ||
28 | &i2c1 { | |
29 | clock-frequency = <400000>; | |
30 | }; | |
31 | ||
32 | &i2c2 { | |
33 | clock-frequency = <400000>; | |
34 | }; | |
218077a3 AK |
35 | |
36 | &gpmc { | |
37 | ranges = <0 0 0x04000000 0x10000000>; | |
38 | ||
39 | /* gpio-irq for dma: 26 */ | |
40 | ||
41 | onenand@0,0 { | |
42 | #address-cells = <1>; | |
43 | #size-cells = <1>; | |
44 | reg = <0 0 0x10000000>; | |
45 | ||
46 | gpmc,sync-read; | |
47 | gpmc,burst-length = <16>; | |
48 | gpmc,burst-read; | |
49 | gpmc,burst-wrap; | |
50 | gpmc,device-width = <2>; | |
51 | gpmc,mux-add-data = <2>; | |
52 | gpmc,cs-on-ns = <0>; | |
53 | gpmc,cs-rd-off-ns = <127>; | |
54 | gpmc,cs-wr-off-ns = <109>; | |
55 | gpmc,adv-on-ns = <0>; | |
56 | gpmc,adv-rd-off-ns = <18>; | |
57 | gpmc,adv-wr-off-ns = <18>; | |
58 | gpmc,oe-on-ns = <27>; | |
59 | gpmc,oe-off-ns = <127>; | |
60 | gpmc,we-on-ns = <27>; | |
61 | gpmc,we-off-ns = <72>; | |
62 | gpmc,rd-cycle-ns = <145>; | |
63 | gpmc,wr-cycle-ns = <136>; | |
64 | gpmc,access-ns = <118>; | |
65 | gpmc,page-burst-access-ns = <27>; | |
66 | gpmc,bus-turnaround-ns = <0>; | |
67 | gpmc,cycle2cycle-delay-ns = <0>; | |
68 | gpmc,wait-monitoring-ns = <0>; | |
69 | gpmc,clk-activation-ns = <9>; | |
70 | gpmc,sync-clk-ps = <27000>; | |
71 | ||
72 | /* MTD partition table corresponding to old board-n8x0 file. */ | |
73 | partition@0 { | |
74 | label = "bootloader"; | |
75 | reg = <0x00000000 0x00020000>; | |
76 | read-only; | |
77 | }; | |
78 | partition@1 { | |
79 | label = "config"; | |
80 | reg = <0x00020000 0x00060000>; | |
81 | }; | |
82 | partition@2 { | |
83 | label = "kernel"; | |
84 | reg = <0x00080000 0x00200000>; | |
85 | }; | |
86 | partition@3 { | |
87 | label = "initfs"; | |
88 | reg = <0x00280000 0x00400000>; | |
89 | }; | |
90 | partition@4 { | |
91 | label = "rootfs"; | |
92 | reg = <0x00680000 0x0f980000>; | |
93 | }; | |
94 | partition@5 { | |
95 | label = "omap2-onenand"; | |
96 | reg = <0x00000000 0x10000000>; | |
97 | }; | |
98 | }; | |
99 | }; |