log: use stderr if syslog initialization fails

[mirror_ifupdown2.git] / debian / changelog

ifupdown2 (1.2.3-1) unstable; urgency=medium

  * Fix: log: use stderr if syslog initialization fails (closes: #917534)

 -- Julien Fortin <julien@cumulusnetworks.com>  Sun, 30 Dec 2018 23:42:42 +0700

ifupdown2 (1.2.2-1) unstable; urgency=medium

  * New: add support for B.A.T.M.A.N. adv. attributes
  * New: support for new iproute2 format (bridge vlan show)
  * New: add new checks for existing device with vxlan attributes
  * Fix: pypi install: local addons modules should be loaded first
  * Fix: link-down yes on vrf slaves
  * Fix: nlmanager: use strerror to format kernel error
  * Fix: ethtool: FEC: translate None and NotSupported values to link-fec off
  * Fix: man: remove non-implemented -m option (closes: #905572)

 -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 20 Dec 2018 23:42:42 +0000

ifupdown2 (1.2.1) UNRELEASED; urgency=medium

  * Fix #54: address module new l3_intf_default_gateway_set_onlink policy
  * Fix: Link down does not work on any intf configured in a VRF
  * Add: ethtool: add link-speed 10 to valid values array
  * Add: address: add l3_intf_arp_accept policy to control ARP_ACCEPT
  * Add: warning when bridge attribute are used on non br[port] intf
  * Add: point-to-point protocol (ppp) addon to create/configure ppp interfaces
  * Add: tunnel support (gretap, ipip, sit, vti, ip6gre, ipip6, ip6ip6, vti6)
  * Add: 0/1/on/off/yes/no support to ip[6]-forward attribute
  * Add: address module_globals policy l3_intf_arp_accept to control ARP_ACCEPT
  * addressvirtual module_globals "addressvirtual_with_route_metric" policy
  * Closes: ethtool: link-fec: local variable 'fec_attrs'
            referencede before assignment
  * Fix: ifquery -r incorrect for address-virtual and vrf configuration under
         an interface

 -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 24 Oct 2018 23:42:42 +0200

ifupdown2 (1.2.0) UNRELEASED; urgency=medium

  * Package architecture refactoring and cleanups
  * Package can be build/install as debian, pip or rpm package
  * Makefile to easily perform tasks (i.e.: install, build, test, upload..)
  * VRF slaves: add support for link-down yes
  * addressvirtual: macvlan: add default metric to ip4 and ip6
  * Closes #48: Run up/down on "manual" interfaces, but ignore any errors.
  * Closes #58: address addon "vlan_aware_bridge_address_support" policy
  * Traditional bridge support for mstpctl attr: (portautoedge, portrestrrole)
  * Configuration for IPv6 link-local auto-generate mode, new attributes:
        ipv6-addrgen (address addon)
        address-virtual-ipv6-addrgen (addressvirtual addon)

 -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 25 Jun 2018 23:42:42 +0200

ifupdown2 (1.1.18) UNRELEASED; urgency=medium

  * Fix: Link down does not work on SVI configured in a VRF
  * Fix: ifreload causes MTU to drop on bridge SVIs
  * Fix: addons: addressvirtual: check if SVI name is first in routing table
  * Fix: ifreload error on deleting bond slaves from an already configured bond
  * Fix: ifupdown2 error is confusing when netmask is specified for vxlan-local-tunnelip
  * Fix: ifupdown2 syntax check needed for vxlan interfaces
  * Fix: vxlan-ageing default timer doesn't align with bridge-ageing
  * Fix: Error with "ifreload -a -n" when MGMT VRF is not Applied
  * Fix: using reserved VLAN range reports error but ifreload returns 0
  * Fix: unable to set bridge-portmcrouter to "2"
  * Fix: vxlan syntax-check warn on missing vxlan-local-tunnelip
  * Fix: traditional bridge svi breaks when extra bridge added
  * Fix: github #39: addons: vrf: fix vrf slave link kind
  * New. Enabled: addons: vxlan: add support for vxlan-port attribute

 -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 12 Apr 2018 11:10:04 +0200

ifupdown2 (1.1.17) UNRELEASED; urgency=medium

  * Fix: ip[6]-forward attributes not set at boot

 -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 08 Feb 2018 09:48:37 +0100

ifupdown2 (1.1.16) UNRELEASED; urgency=medium

  * Fix: python exception on macvlans address dump
  * Fix: eth0 doesn't acquire DHCP address when mgmt VRF is enabled

 -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 09 Jan 2018 02:02:58 +0100

ifupdown2 (1.1.15) UNRELEASED; urgency=medium

  * New. Enabled: bridge: add support for bridge-l2protocol-tunnel
  * New. Enabled: bridge attributes, when removed reset to default
  * New. Enabled: vxlan attributes, when removed reset to default
  * New. Enabled: improve handling of optional resources (if missing bridge-utils/ethtool)
  * Fix: policy "iface_defaults" not supported for MTU
  * Fix: address module: handling of ipv4 & ipv6 (add/remove)
  * Fix: warning for vlan reserved range
  * Fix: MTU handling on bridge SVIs

 -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 22 Nov 2017 19:07:43 +0100

ifupdown2 (1.1.14) UNRELEASED; urgency=medium

  * New. Enabled: default policy for bridge MAC address
  * Fix: ethtool: don't set link speed and duplex if autoneg is on

 -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 25 Oct 2017 23:12:27 +0200

ifupdown2 (1.1.13) UNRELEASED; urgency=medium

  * Fix: VRF: ssh session not killed on ifreload

 -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 15 Sep 2017 22:43:12 +0200

ifupdown2 (1.1.12) UNRELEASED; urgency=medium

  * New. Enabled: mpls-enable attribute
  * New. Enabled: bond and bridge module moved to netlink configuration
  * New. Enabled: handle a mix of auto and specified vrf table ids
  * Fix: igmp attribute reset to defaults when removed from config

 -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 07 Aug 2017 22:14:03 +0200

ifupdown2 (1.1.11) UNRELEASED; urgency=medium

  * Fix: link-down attribute not applied on slave ports
  * Fix: bug that prevented config of mtu below 1280

 -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 18 May 2017 12:45:21 -0700

ifupdown2 (1.1.10) UNRELEASED; urgency=medium

  * New. Enabled: drop the dependency to pkg_resources, hardcode version number (closes: #855401)
  * New. Enabled: adjust allow-hotplug behavior to ifupdown (closes: #855598)
  * New. Enabled: bond-lacp-rate support slow/fast argument
  * New. Enabled: ifquery --syntax-help: add support for json output
  * New. Enabled: vlan: add new attribute 'vlan-protocol'
  * New. Enabled: address: add new attribute 'ip6-forward'
  * New. Enabled: bridge: add new attribute 'bridge-mcstats'
  * New. Enabled: bridge: add new attribute 'bridge-vlan-stats'
  * New. Enabled: bridge: add new attribute 'bridge-vlan-protocol'
  * New. Enabled: bridge: add new attribute 'bridge-arp-nd-suppress'
  * Fix: bond: add attribute bond-(up|down)delay
  * Fix: bridge-vids: --syntax-check accepts legacy syntax

 -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 17 Apr 2017 06:18:04 +0200

ifupdown2 (1.1.9) UNRELEASED; urgency=medium

  * New. Enabled: support for bridge-learning attribute

 -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 06 Feb 2017 13:22:51 -0800

ifupdown2 (1.1.8) UNRELEASED; urgency=medium

  * New. Enabled: update link-speed values: add 25G and 50G
  * New. Enabled: new 'link-down' [yes|no] attribute to keep link down

 -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 17 Jan 2017 08:39:29 +0100

ifupdown2 (1.1.7) UNRELEASED; urgency=medium

  * New. Enabled: fix for inet and inet6 dhcp on the same interface
  * New. Enabled: syntax check to warn on common configuration mistakes
  * New. Enabled: addons: bridge: disable ip fwding on a bridge with no ip
    and no upperifaces
  * Fix: fixes for MTU handling
  * Fix: dhcpv6 fails if interface doesn't have link-local addr

 -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 07 Dec 2016 05:48:45 +0100

ifupdown2 (1.1.6) UNRELEASED; urgency=medium

  * Closes: github #14. add environment variables passed to user scripts
  * New. Enabled: addons may provide a list of ifupdown scripts to ignore

 -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 19 Sep 2016 16:37:36 -0700

ifupdown2 (1.1.5) UNRELEASED; urgency=medium

  * Fix: handling of EXISTS errors on address add
  * Fix: handling of mtu on addressvirtual macvlan devices
  * Fix: mako namespace handling

 -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 16 Sep 2016 12:48:04 -0700

ifupdown2 (1.1.4) UNRELEASED; urgency=medium

  * Performance improvements
  * New. Enabled: sbin: start-networking: support hotplug class from init script
  * New. Enabled: support for classical numerical bond modes
  * New. Enabled: extend ifquery support for mstpctl addons
  * New. Enabled: each addon may perform semantic and syntax checks by
    implementing a custom method
  * Fix: Support for address-virtual lines under a vrf slave
  * Fix: Defaults for link attributes were not applied
  * Fix: Disable IPv6 duplicate address detection on VRR interfaces
  * Fix: ifquery to extract vlan-id from iface if not preset
  * Fix: ifquery -c bridge pvid error on a valid config

 -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 29 Jul 2016 08:55:50 -0700

ifupdown2 (1.1.3) UNRELEASED; urgency=medium

  * Fix: Interface configuration parsing error when keyword vlan
    is the interface name.

 -- Julien Fortin <julien@cumulusnetworks.com>  Sun, 05 Jun 2016 08:55:50 -0700

ifupdown2 (1.1.2) UNRELEASED; urgency=medium

  * Fix: checks for invalid address-virtual attributes
  * New. Deprecated: `mstpctl-stp` attribute
  * New. Deprecated: lacp parameters: bond-ad-sys-priority, bond-ad-sys-mac-addr
  * New. Enabled: addon module for configuring vrf
  * New. Enabled: bridge: display warning when (in vlan unware bridge)
    an untagged bridge is not configured
  * New. Enabled: adjusting MTU for vlan devices depending on lower device mtu
  * New. Enabled: introduce checks for reserved vrf table names
  * New. Enabled: ifquery: new option '--with-defaults' to include default
    attributes
  * New. Enabled: bridge: disabling ipv6 on bridge if any VXLAN port
  * New. Enabled: vrf awareness in dhcp addon module

 -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 3 May 2016 14:42:42 -0700

ifupdown2 (1.1) unstable; urgency=low

  * Initial release.

 -- Roopa Prabhu <roopa@cumulusnetworks.com>  Thu, 20 Aug 2015 06:14:24 -0700