]>
Commit | Line | Data |
---|---|---|
73a59c1c SP |
1 | /* |
2 | * include/asm-arm/arch-at91rm9200/board.h | |
3 | * | |
4 | * Copyright (C) 2005 HP Labs | |
5 | * | |
6 | * This program is free software; you can redistribute it and/or modify | |
7 | * it under the terms of the GNU General Public License as published by | |
8 | * the Free Software Foundation; either version 2 of the License, or | |
9 | * (at your option) any later version. | |
10 | * | |
11 | * This program is distributed in the hope that it will be useful, | |
12 | * but WITHOUT ANY WARRANTY; without even the implied warranty of | |
13 | * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the | |
14 | * GNU General Public License for more details. | |
15 | * | |
16 | * You should have received a copy of the GNU General Public License | |
17 | * along with this program; if not, write to the Free Software | |
18 | * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA 02111-1307 USA | |
19 | */ | |
20 | ||
21 | /* | |
22 | * These are data structures found in platform_device.dev.platform_data, | |
d254c8f7 | 23 | * and describing board-specific data needed by drivers. For example, |
73a59c1c SP |
24 | * which pin is used for a given GPIO role. |
25 | * | |
26 | * In 2.6, drivers should strongly avoid board-specific knowledge so | |
27 | * that supporting new boards normally won't require driver patches. | |
28 | * Most board-specific knowledge should be in arch/.../board-*.c files. | |
29 | */ | |
30 | ||
31 | #ifndef __ASM_ARCH_BOARD_H | |
32 | #define __ASM_ARCH_BOARD_H | |
33 | ||
3267c077 | 34 | #include <linux/mtd/partitions.h> |
82dc0772 AV |
35 | #include <linux/device.h> |
36 | #include <linux/spi/spi.h> | |
3267c077 | 37 | |
73a59c1c SP |
38 | /* USB Device */ |
39 | struct at91_udc_data { | |
40 | u8 vbus_pin; /* high == host powering us */ | |
41 | u8 pullup_pin; /* high == D+ pulled up */ | |
42 | }; | |
43 | extern void __init at91_add_device_udc(struct at91_udc_data *data); | |
44 | ||
45 | /* Compact Flash */ | |
46 | struct at91_cf_data { | |
47 | u8 irq_pin; /* I/O IRQ */ | |
48 | u8 det_pin; /* Card detect */ | |
49 | u8 vcc_pin; /* power switching */ | |
50 | u8 rst_pin; /* card reset */ | |
51 | }; | |
52 | extern void __init at91_add_device_cf(struct at91_cf_data *data); | |
53 | ||
54 | /* MMC / SD */ | |
55 | struct at91_mmc_data { | |
56 | u8 det_pin; /* card detect IRQ */ | |
57 | unsigned is_b:1; /* uses B side (vs A) */ | |
58 | unsigned wire4:1; /* (SD) supports DAT0..DAT3 */ | |
59 | u8 wp_pin; /* (SD) writeprotect detect */ | |
60 | u8 vcc_pin; /* power switching (high == on) */ | |
61 | }; | |
62 | extern void __init at91_add_device_mmc(struct at91_mmc_data *data); | |
63 | ||
64 | /* Ethernet */ | |
65 | struct at91_eth_data { | |
66 | u8 phy_irq_pin; /* PHY IRQ */ | |
67 | u8 is_rmii; /* using RMII interface? */ | |
68 | }; | |
69 | extern void __init at91_add_device_eth(struct at91_eth_data *data); | |
70 | ||
71 | /* USB Host */ | |
72 | struct at91_usbh_data { | |
73 | u8 ports; /* number of ports on root hub */ | |
74 | }; | |
75 | extern void __init at91_add_device_usbh(struct at91_usbh_data *data); | |
76 | ||
3267c077 AV |
77 | /* NAND / SmartMedia */ |
78 | struct at91_nand_data { | |
79 | u8 enable_pin; /* chip enable */ | |
80 | u8 det_pin; /* card detect */ | |
81 | u8 rdy_pin; /* ready/busy */ | |
82 | u8 ale; /* address line number connected to ALE */ | |
83 | u8 cle; /* address line number connected to CLE */ | |
84 | struct mtd_partition* (*partition_info)(int, int*); | |
85 | }; | |
86 | extern void __init at91_add_device_nand(struct at91_nand_data *data); | |
87 | ||
88 | /* I2C*/ | |
82dc0772 | 89 | extern void __init at91_add_device_i2c(void); |
3267c077 | 90 | |
82dc0772 AV |
91 | /* SPI */ |
92 | extern void __init at91_add_device_spi(struct spi_board_info *devices, int nr_devices); | |
93 | ||
94 | /* Serial */ | |
95 | struct at91_uart_config { | |
96 | unsigned short console_tty; /* tty number of serial console */ | |
97 | unsigned short nr_tty; /* number of serial tty's */ | |
98 | short tty_map[]; /* map UART to tty number */ | |
99 | }; | |
73e2798b | 100 | extern struct platform_device *atmel_default_console_device; |
82dc0772 AV |
101 | extern void __init at91_init_serial(struct at91_uart_config *config); |
102 | ||
73e2798b | 103 | struct atmel_uart_data { |
82dc0772 AV |
104 | short use_dma_tx; /* use transmit DMA? */ |
105 | short use_dma_rx; /* use receive DMA? */ | |
106 | }; | |
107 | extern void __init at91_add_device_serial(void); | |
3267c077 | 108 | |
cc2832a1 AV |
109 | /* LEDs */ |
110 | extern u8 at91_leds_cpu; | |
111 | extern u8 at91_leds_timer; | |
112 | extern void __init at91_init_leds(u8 cpu_led, u8 timer_led); | |
113 | ||
73a59c1c | 114 | #endif |