Documentation/hwmon/shtc1

   1 Kernel driver shtc1
   2 ===================
   3
   4 Supported chips:
   5   * Sensirion SHTC1
   6     Prefix: 'shtc1'
   7     Addresses scanned: none
   8     Datasheet: http://www.sensirion.com/file/datasheet_shtc1
   9
  10   * Sensirion SHTW1
  11     Prefix: 'shtw1'
  12     Addresses scanned: none
  13     Datasheet: Not publicly available
  14
  15 Author:
  16   Johannes Winkelmann <johannes.winkelmann@sensirion.com>
  17
  18 Description
  19 -----------
  20
  21 This driver implements support for the Sensirion SHTC1 chip, a humidity and
  22 temperature sensor. Temperature is measured in degrees celsius, relative
  23 humidity is expressed as a percentage. Driver can be used as well for SHTW1
  24 chip, which has the same electrical interface.
  25
  26 The device communicates with the I2C protocol. All sensors are set to I2C
  27 address 0x70. See Documentation/i2c/instantiating-devices for methods to
  28 instantiate the device.
  29
  30 There are two options configurable by means of shtc1_platform_data:
  31 1. blocking (pull the I2C clock line down while performing the measurement) or
  32    non-blocking mode. Blocking mode will guarantee the fastest result but
  33    the I2C bus will be busy during that time. By default, non-blocking mode
  34    is used. Make sure clock-stretching works properly on your device if you
  35    want to use blocking mode.
  36 2. high or low accuracy. High accuracy is used by default and using it is
  37    strongly recommended.
  38
  39 sysfs-Interface
  40 ---------------
  41
  42 temp1_input - temperature input
  43 humidity1_input - humidity input