arch/arm/boot/dts/kirkwood-ts419.dtsi

   1 // SPDX-License-Identifier: GPL-2.0+
   2 /*
   3  * Device Tree include file for QNAP TS41X
   4  *
   5  * Copyright (C) 2013, Andrew Lunn <andrew@lunn.ch>
   6  */
   7
   8 / {
   9         model = "QNAP TS419 family";
  10         compatible = "qnap,ts419", "marvell,kirkwood";
  11
  12         ocp@f1000000 {
  13                 pinctrl: pin-controller@10000 {
  14                         pinctrl-names = "default";
  15
  16                         pmx_USB_copy_button: pmx-USB-copy-button {
  17                                 marvell,pins = "mpp43";
  18                                 marvell,function = "gpio";
  19                         };
  20                         pmx_reset_button: pmx-reset-button {
  21                                 marvell,pins = "mpp37";
  22                                 marvell,function = "gpio";
  23                         };
  24                         /*
  25                          * JP1 indicates if an LCD module is installed
  26                          * on the serial port (0), or if the port is used
  27                          * as a console (1).
  28                          */
  29                         pmx_jumper_jp1: pmx-jumper_jp1 {
  30                                 marvell,pins = "mpp45";
  31                                 marvell,function = "gpio";
  32                         };
  33
  34                 };
  35         };
  36
  37         gpio_keys {
  38                 compatible = "gpio-keys";
  39                 #address-cells = <1>;
  40                 #size-cells = <0>;
  41                 pinctrl-0 = <&pmx_reset_button &pmx_USB_copy_button>;
  42                 pinctrl-names = "default";
  43
  44                 copy {
  45                         label = "USB Copy";
  46                         linux,code = <KEY_COPY>;
  47                         gpios = <&gpio1 11 GPIO_ACTIVE_LOW>;
  48                 };
  49                 reset {
  50                         label = "Reset";
  51                         linux,code = <KEY_RESTART>;
  52                         gpios = <&gpio1 5 GPIO_ACTIVE_LOW>;
  53                 };
  54         };
  55 };
  56
  57 &mdio {
  58         status = "okay";
  59
  60         ethphy1: ethernet-phy@1 {
  61                 device_type = "ethernet-phy";
  62                 /* overwrite reg property in board file */
  63         };
  64 };
  65
  66 &eth1 {
  67         status = "okay";
  68         ethernet1-port@0 {
  69                 phy-handle = <&ethphy1>;
  70         };
  71 };