arch/powerpc/platforms/52xx/Kconfig

   1 config PPC_MPC52xx
   2         bool "52xx-based boards"
   3         depends on 6xx
   4         select COMMON_CLK
   5         select PPC_PCI_CHOICE
   6
   7 config PPC_MPC5200_SIMPLE
   8         bool "Generic support for simple MPC5200 based boards"
   9         depends on PPC_MPC52xx
  10         select DEFAULT_UIMAGE
  11         help
  12           This option enables support for a simple MPC52xx based boards which
  13           do not need a custom platform specific setup. Such boards are
  14           supported assuming the following:
  15
  16           - GPIO pins are configured by the firmware,
  17           - CDM configuration (clocking) is setup correctly by firmware,
  18           - if the 'fsl,has-wdt' property is present in one of the
  19             gpt nodes, then it is safe to use such gpt to reset the board,
  20           - PCI is supported if enabled in the kernel configuration
  21             and if there is a PCI bus node defined in the device tree.
  22
  23           Boards that are compatible with this generic platform support
  24           are:
  25              intercontrol,digsy-mtc
  26              phytec,pcm030
  27              phytec,pcm032
  28              promess,motionpro
  29              schindler,cm5200
  30              tqc,tqm5200
  31
  32 config PPC_EFIKA
  33         bool "bPlan Efika 5k2. MPC5200B based computer"
  34         depends on PPC_MPC52xx
  35         select PPC_RTAS
  36         select PPC_NATIVE
  37
  38 config PPC_LITE5200
  39         bool "Freescale Lite5200 Eval Board"
  40         depends on PPC_MPC52xx
  41         select DEFAULT_UIMAGE
  42
  43 config PPC_MEDIA5200
  44         bool "Freescale Media5200 Eval Board"
  45         depends on PPC_MPC52xx
  46         select DEFAULT_UIMAGE
  47
  48 config PPC_MPC5200_BUGFIX
  49         bool "MPC5200 (L25R) bugfix support"
  50         depends on PPC_MPC52xx
  51         help
  52           Enable workarounds for original MPC5200 errata.  This is not required
  53           for MPC5200B based boards.
  54
  55           It is safe to say 'Y' here
  56
  57 config PPC_MPC5200_LPBFIFO
  58         tristate "MPC5200 LocalPlus bus FIFO driver"
  59         depends on PPC_MPC52xx && PPC_BESTCOMM
  60         select PPC_BESTCOMM_GEN_BD