]>
git.proxmox.com Git - mirror_ubuntu-eoan-kernel.git/blob - drivers/net/8390.h
1 /* Generic NS8390 register definitions. */
2 /* This file is part of Donald Becker's 8390 drivers, and is distributed
3 under the same license. Auto-loading of 8390.o only in v2.2 - Paul G.
4 Some of these names and comments originated from the Crynwr
5 packet drivers, which are distributed under the GPL. */
10 #include <linux/if_ether.h>
11 #include <linux/ioport.h>
12 #include <linux/skbuff.h>
14 #define TX_PAGES 12 /* Two Tx slots */
16 #define ETHER_ADDR_LEN 6
18 /* The 8390 specific per-packet-header format. */
19 struct e8390_pkt_hdr
{
20 unsigned char status
; /* status */
21 unsigned char next
; /* pointer to next packet. */
22 unsigned short count
; /* header + packet length in bytes */
31 #ifdef CONFIG_NET_POLL_CONTROLLER
32 extern void ei_poll(struct net_device
*dev
);
35 extern void NS8390_init(struct net_device
*dev
, int startp
);
36 extern int ei_open(struct net_device
*dev
);
37 extern int ei_close(struct net_device
*dev
);
38 extern irqreturn_t
ei_interrupt(int irq
, void *dev_id
, struct pt_regs
*regs
);
39 extern struct net_device
*__alloc_ei_netdev(int size
);
40 static inline struct net_device
*alloc_ei_netdev(void)
42 return __alloc_ei_netdev(0);
45 /* You have one of these per-board */
48 void (*reset_8390
)(struct net_device
*);
49 void (*get_8390_hdr
)(struct net_device
*, struct e8390_pkt_hdr
*, int);
50 void (*block_output
)(struct net_device
*, int, const unsigned char *, int);
51 void (*block_input
)(struct net_device
*, int, struct sk_buff
*, int);
52 unsigned long rmem_start
;
53 unsigned long rmem_end
;
55 unsigned char mcfilter
[8];
57 unsigned word16
:1; /* We have the 16-bit (vs 8-bit) version of the card. */
58 unsigned bigendian
:1; /* 16-bit big endian mode. Do NOT */
59 /* set this on random 8390 clones! */
60 unsigned txing
:1; /* Transmit Active */
61 unsigned irqlock
:1; /* 8390's intrs disabled when '1'. */
62 unsigned dmaing
:1; /* Remote DMA Active */
63 unsigned char tx_start_page
, rx_start_page
, stop_page
;
64 unsigned char current_page
; /* Read pointer in buffer */
65 unsigned char interface_num
; /* Net port (AUI, 10bT.) to use. */
66 unsigned char txqueue
; /* Tx Packet buffer queue length. */
67 short tx1
, tx2
; /* Packet lengths for ping-pong tx. */
68 short lasttx
; /* Alpha version consistency check. */
69 unsigned char reg0
; /* Register '0' in a WD8013 */
70 unsigned char reg5
; /* Register '5' in a WD8013 */
71 unsigned char saved_irq
; /* Original dev->irq value. */
72 struct net_device_stats stat
; /* The new statistics table. */
73 u32
*reg_offset
; /* Register mapping table */
74 spinlock_t page_lock
; /* Page register locks */
75 unsigned long priv
; /* Private field to store bus IDs etc. */
78 /* The maximum number of 8390 interrupt service routines called per IRQ. */
79 #define MAX_SERVICE 12
81 /* The maximum time waited (in jiffies) before assuming a Tx failed. (20ms) */
82 #define TX_TIMEOUT (20*HZ/100)
84 #define ei_status (*(struct ei_device *)netdev_priv(dev))
86 /* Some generic ethernet register configurations. */
87 #define E8390_TX_IRQ_MASK 0xa /* For register EN0_ISR */
88 #define E8390_RX_IRQ_MASK 0x5
89 #define E8390_RXCONFIG 0x4 /* EN0_RXCR: broadcasts, no multicast,errors */
90 #define E8390_RXOFF 0x20 /* EN0_RXCR: Accept no packets */
91 #define E8390_TXCONFIG 0x00 /* EN0_TXCR: Normal transmit mode */
92 #define E8390_TXOFF 0x02 /* EN0_TXCR: Transmitter off */
94 /* Register accessed at EN_CMD, the 8390 base addr. */
95 #define E8390_STOP 0x01 /* Stop and reset the chip */
96 #define E8390_START 0x02 /* Start the chip, clear reset */
97 #define E8390_TRANS 0x04 /* Transmit a frame */
98 #define E8390_RREAD 0x08 /* Remote read */
99 #define E8390_RWRITE 0x10 /* Remote write */
100 #define E8390_NODMA 0x20 /* Remote DMA */
101 #define E8390_PAGE0 0x00 /* Select page chip registers */
102 #define E8390_PAGE1 0x40 /* using the two high-order bits */
103 #define E8390_PAGE2 0x80 /* Page 3 is invalid. */
106 * Only generate indirect loads given a machine that needs them.
107 * - removed AMIGA_PCMCIA from this list, handled as ISA io now
110 #if defined(CONFIG_MAC) || \
111 defined(CONFIG_ZORRO8390) || defined(CONFIG_ZORRO8390_MODULE) || \
112 defined(CONFIG_HYDRA) || defined(CONFIG_HYDRA_MODULE)
113 #define EI_SHIFT(x) (ei_local->reg_offset[x])
119 #define inb(port) in_8(port)
120 #define outb(val,port) out_8(port,val)
121 #define inb_p(port) in_8(port)
122 #define outb_p(val,port) out_8(port,val)
124 #elif defined(CONFIG_ARM_ETHERH) || defined(CONFIG_ARM_ETHERH_MODULE)
125 #define EI_SHIFT(x) (ei_local->reg_offset[x])
131 #define inb(_p) readb(_p)
132 #define outb(_v,_p) writeb(_v,_p)
133 #define inb_p(_p) inb(_p)
134 #define outb_p(_v,_p) outb(_v,_p)
136 #elif defined(CONFIG_NE_H8300) || defined(CONFIG_NE_H8300_MODULE)
137 #define EI_SHIFT(x) (ei_local->reg_offset[x])
139 #define EI_SHIFT(x) (x)
142 #define E8390_CMD EI_SHIFT(0x00) /* The command register (for all pages) */
143 /* Page 0 register offsets. */
144 #define EN0_CLDALO EI_SHIFT(0x01) /* Low byte of current local dma addr RD */
145 #define EN0_STARTPG EI_SHIFT(0x01) /* Starting page of ring bfr WR */
146 #define EN0_CLDAHI EI_SHIFT(0x02) /* High byte of current local dma addr RD */
147 #define EN0_STOPPG EI_SHIFT(0x02) /* Ending page +1 of ring bfr WR */
148 #define EN0_BOUNDARY EI_SHIFT(0x03) /* Boundary page of ring bfr RD WR */
149 #define EN0_TSR EI_SHIFT(0x04) /* Transmit status reg RD */
150 #define EN0_TPSR EI_SHIFT(0x04) /* Transmit starting page WR */
151 #define EN0_NCR EI_SHIFT(0x05) /* Number of collision reg RD */
152 #define EN0_TCNTLO EI_SHIFT(0x05) /* Low byte of tx byte count WR */
153 #define EN0_FIFO EI_SHIFT(0x06) /* FIFO RD */
154 #define EN0_TCNTHI EI_SHIFT(0x06) /* High byte of tx byte count WR */
155 #define EN0_ISR EI_SHIFT(0x07) /* Interrupt status reg RD WR */
156 #define EN0_CRDALO EI_SHIFT(0x08) /* low byte of current remote dma address RD */
157 #define EN0_RSARLO EI_SHIFT(0x08) /* Remote start address reg 0 */
158 #define EN0_CRDAHI EI_SHIFT(0x09) /* high byte, current remote dma address RD */
159 #define EN0_RSARHI EI_SHIFT(0x09) /* Remote start address reg 1 */
160 #define EN0_RCNTLO EI_SHIFT(0x0a) /* Remote byte count reg WR */
161 #define EN0_RCNTHI EI_SHIFT(0x0b) /* Remote byte count reg WR */
162 #define EN0_RSR EI_SHIFT(0x0c) /* rx status reg RD */
163 #define EN0_RXCR EI_SHIFT(0x0c) /* RX configuration reg WR */
164 #define EN0_TXCR EI_SHIFT(0x0d) /* TX configuration reg WR */
165 #define EN0_COUNTER0 EI_SHIFT(0x0d) /* Rcv alignment error counter RD */
166 #define EN0_DCFG EI_SHIFT(0x0e) /* Data configuration reg WR */
167 #define EN0_COUNTER1 EI_SHIFT(0x0e) /* Rcv CRC error counter RD */
168 #define EN0_IMR EI_SHIFT(0x0f) /* Interrupt mask reg WR */
169 #define EN0_COUNTER2 EI_SHIFT(0x0f) /* Rcv missed frame error counter RD */
171 /* Bits in EN0_ISR - Interrupt status register */
172 #define ENISR_RX 0x01 /* Receiver, no error */
173 #define ENISR_TX 0x02 /* Transmitter, no error */
174 #define ENISR_RX_ERR 0x04 /* Receiver, with error */
175 #define ENISR_TX_ERR 0x08 /* Transmitter, with error */
176 #define ENISR_OVER 0x10 /* Receiver overwrote the ring */
177 #define ENISR_COUNTERS 0x20 /* Counters need emptying */
178 #define ENISR_RDC 0x40 /* remote dma complete */
179 #define ENISR_RESET 0x80 /* Reset completed */
180 #define ENISR_ALL 0x3f /* Interrupts we will enable */
182 /* Bits in EN0_DCFG - Data config register */
183 #define ENDCFG_WTS 0x01 /* word transfer mode selection */
184 #define ENDCFG_BOS 0x02 /* byte order selection */
186 /* Page 1 register offsets. */
187 #define EN1_PHYS EI_SHIFT(0x01) /* This board's physical enet addr RD WR */
188 #define EN1_PHYS_SHIFT(i) EI_SHIFT(i+1) /* Get and set mac address */
189 #define EN1_CURPAG EI_SHIFT(0x07) /* Current memory page RD WR */
190 #define EN1_MULT EI_SHIFT(0x08) /* Multicast filter mask array (8 bytes) RD WR */
191 #define EN1_MULT_SHIFT(i) EI_SHIFT(8+i) /* Get and set multicast filter */
193 /* Bits in received packet status byte and EN0_RSR*/
194 #define ENRSR_RXOK 0x01 /* Received a good packet */
195 #define ENRSR_CRC 0x02 /* CRC error */
196 #define ENRSR_FAE 0x04 /* frame alignment error */
197 #define ENRSR_FO 0x08 /* FIFO overrun */
198 #define ENRSR_MPA 0x10 /* missed pkt */
199 #define ENRSR_PHY 0x20 /* physical/multicast address */
200 #define ENRSR_DIS 0x40 /* receiver disable. set in monitor mode */
201 #define ENRSR_DEF 0x80 /* deferring */
203 /* Transmitted packet status, EN0_TSR. */
204 #define ENTSR_PTX 0x01 /* Packet transmitted without error */
205 #define ENTSR_ND 0x02 /* The transmit wasn't deferred. */
206 #define ENTSR_COL 0x04 /* The transmit collided at least once. */
207 #define ENTSR_ABT 0x08 /* The transmit collided 16 times, and was deferred. */
208 #define ENTSR_CRS 0x10 /* The carrier sense was lost. */
209 #define ENTSR_FU 0x20 /* A "FIFO underrun" occurred during transmit. */
210 #define ENTSR_CDH 0x40 /* The collision detect "heartbeat" signal was lost. */
211 #define ENTSR_OWC 0x80 /* There was an out-of-window collision. */