drivers/net/ethernet/qualcomm/Kconfig

   1 # SPDX-License-Identifier: GPL-2.0-only
   2 #
   3 # Qualcomm network device configuration
   4 #
   5
   6 config NET_VENDOR_QUALCOMM
   7         bool "Qualcomm devices"
   8         default y
   9         ---help---
  10           If you have a network (Ethernet) card belonging to this class, say Y.
  11
  12           Note that the answer to this question doesn't directly affect the
  13           kernel: saying N will just cause the configurator to skip all
  14           the questions about Qualcomm cards. If you say Y, you will be asked
  15           for your specific card in the following questions.
  16
  17 if NET_VENDOR_QUALCOMM
  18
  19 config QCA7000
  20         tristate
  21         help
  22           This enables support for the Qualcomm Atheros QCA7000.
  23
  24 config QCA7000_SPI
  25         tristate "Qualcomm Atheros QCA7000 SPI support"
  26         select QCA7000
  27         depends on SPI_MASTER && OF
  28         ---help---
  29           This SPI protocol driver supports the Qualcomm Atheros QCA7000.
  30
  31           To compile this driver as a module, choose M here. The module
  32           will be called qcaspi.
  33
  34 config QCA7000_UART
  35         tristate "Qualcomm Atheros QCA7000 UART support"
  36         select QCA7000
  37         depends on SERIAL_DEV_BUS && OF
  38         ---help---
  39           This UART protocol driver supports the Qualcomm Atheros QCA7000.
  40
  41           Currently the driver assumes these device UART settings:
  42             Data bits: 8
  43             Parity: None
  44             Stop bits: 1
  45             Flow control: None
  46
  47           To compile this driver as a module, choose M here. The module
  48           will be called qcauart.
  49
  50 config QCOM_EMAC
  51         tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support"
  52         depends on HAS_DMA && HAS_IOMEM
  53         select CRC32
  54         select PHYLIB
  55         ---help---
  56           This driver supports the Qualcomm Technologies, Inc. Gigabit
  57           Ethernet Media Access Controller (EMAC). The controller
  58           supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s,
  59           full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for
  60           low power, Receive-Side Scaling (RSS), and IEEE 1588-2008
  61           Precision Clock Synchronization Protocol.
  62
  63 source "drivers/net/ethernet/qualcomm/rmnet/Kconfig"
  64
  65 endif # NET_VENDOR_QUALCOMM