2 # PHY Layer Configuration
6 tristate "MDIO bus device drivers"
8 MDIO devices and driver infrastructure code.
15 This internal symbol is used for link time dependencies and it
16 reflects whether the mdio_bus/mdio_device code is built as a
17 loadable module or built-in.
22 tristate "Broadcom iProc MDIO bus controller"
23 depends on ARCH_BCM_IPROC || COMPILE_TEST
24 depends on HAS_IOMEM && OF_MDIO
26 This module provides a driver for the MDIO busses found in the
29 config MDIO_BCM_UNIMAC
30 tristate "Broadcom UniMAC MDIO bus controller"
31 depends on HAS_IOMEM && OF_MDIO
33 This module provides a driver for the Broadcom UniMAC MDIO busses.
34 This hardware can be found in the Broadcom GENET Ethernet MAC
35 controllers as well as some Broadcom Ethernet switches such as the
36 Starfighter 2 switches.
39 tristate "Bitbanged MDIO buses"
41 This module implements the MDIO bus protocol in software,
42 for use by low level drivers that export the ability to
43 drive the relevant pins.
51 This module provides a driver framework for MDIO bus
52 multiplexers which connect one of several child MDIO busses
53 to a parent bus. Switching between child busses is done by
54 device specific drivers.
56 config MDIO_BUS_MUX_BCM_IPROC
57 tristate "Broadcom iProc based MDIO bus multiplexers"
58 depends on OF && OF_MDIO && (ARCH_BCM_IPROC || COMPILE_TEST)
60 default ARCH_BCM_IPROC
62 This module provides a driver for MDIO bus multiplexers found in
63 iProc based Broadcom SoCs. This multiplexer connects one of several
64 child MDIO bus to a parent bus. Buses could be internal as well as
65 external and selection logic lies inside the same multiplexer.
67 config MDIO_BUS_MUX_GPIO
68 tristate "GPIO controlled MDIO bus multiplexers"
69 depends on OF_GPIO && OF_MDIO
72 This module provides a driver for MDIO bus multiplexers that
73 are controlled via GPIO lines. The multiplexer connects one of
74 several child MDIO busses to a parent bus. Child bus
75 selection is under the control of GPIO lines.
77 config MDIO_BUS_MUX_MMIOREG
78 tristate "MMIO device-controlled MDIO bus multiplexers"
79 depends on OF_MDIO && HAS_IOMEM
82 This module provides a driver for MDIO bus multiplexers that
83 are controlled via a simple memory-mapped device, like an FPGA.
84 The multiplexer connects one of several child MDIO busses to a
85 parent bus. Child bus selection is under the control of one of
88 Currently, only 8-bit registers are supported.
94 tristate "GPIO lib-based bitbanged MDIO buses"
95 depends on MDIO_BITBANG && GPIOLIB
97 Supports GPIO lib-based MDIO busses.
99 To compile this driver as a module, choose M here: the module
100 will be called mdio-gpio.
102 config MDIO_HISI_FEMAC
103 tristate "Hisilicon FEMAC MDIO bus controller"
104 depends on HAS_IOMEM && OF_MDIO
106 This module provides a driver for the MDIO busses found in the
107 Hisilicon SoC that have an Fast Ethernet MAC.
110 tristate "MOXA ART MDIO interface support"
111 depends on ARCH_MOXART
113 This driver supports the MDIO interface found in the network
114 interface units of the MOXA ART SoC
117 tristate "Octeon and some ThunderX SOCs MDIO buses"
119 depends on HAS_IOMEM && OF_MDIO
122 This module provides a driver for the Octeon and ThunderX MDIO
123 buses. It is required by the Octeon and ThunderX ethernet device
124 drivers on some systems.
127 tristate "Allwinner sun4i MDIO interface support"
128 depends on ARCH_SUNXI
130 This driver supports the MDIO interface found in the network
131 interface units of the Allwinner SoC that have an EMAC (A10,
135 tristate "ThunderX SOCs MDIO buses"
140 This driver supports the MDIO interfaces found on Cavium
141 ThunderX SoCs when the MDIO bus device appears as a PCI
145 tristate "APM X-Gene SoC MDIO bus controller"
146 depends on ARCH_XGENE || COMPILE_TEST
148 This module provides a driver for the MDIO busses found in the
154 tristate "PHY Device support and infrastructure"
155 depends on NETDEVICES
158 Ethernet controllers are usually attached to PHY
159 devices. This option provides infrastructure for
160 managing PHY devices.
167 config LED_TRIGGER_PHY
168 bool "Support LED triggers for tracking link state"
169 depends on LEDS_TRIGGERS
171 Adds support for a set of LED trigger events per-PHY. Link
172 state change will trigger the events, for consumption by an
173 LED class driver. There are triggers for each link speed currently
174 supported by the phy, and are of the form:
175 <mii bus id>:<phy>:<speed>
177 Where speed is in the form:
178 <Speed in megabits>Mbps or <Speed in gigabits>Gbps
181 comment "MII PHY device drivers"
186 Currently supports the am79c874
189 tristate "Aquantia PHYs"
191 Currently supports the Aquantia AQ1202, AQ2104, AQR105, AQR405
194 tristate "AT803X PHYs"
196 Currently supports the AT8030 and AT8035 model
199 tristate "Broadcom 63xx SOCs internal PHY"
201 select BCM_NET_PHYLIB
203 Currently supports the 6348 and 6358 PHYs.
206 tristate "Broadcom 7xxx SOCs internal PHYs"
207 select BCM_NET_PHYLIB
209 Currently supports the BCM7366, BCM7439, BCM7445, and
210 40nm and 65nm generation of BCM7xxx Set Top Box SoCs.
213 tristate "Broadcom BCM8706 and BCM8727 PHYs"
215 Currently supports the BCM8706 and BCM8727 10G Ethernet PHYs.
217 config BCM_CYGNUS_PHY
218 tristate "Broadcom Cygnus SoC internal PHY"
219 depends on ARCH_BCM_CYGNUS || COMPILE_TEST
220 depends on MDIO_BCM_IPROC
221 select BCM_NET_PHYLIB
223 This PHY driver is for the 1G internal PHYs of the Broadcom
226 Currently supports internal PHY's used in the BCM11300,
227 BCM11320, BCM11350, BCM11360, BCM58300, BCM58302,
228 BCM58303 & BCM58305 Broadcom Cygnus SoCs.
230 config BCM_NET_PHYLIB
234 tristate "Broadcom PHYs"
235 select BCM_NET_PHYLIB
237 Currently supports the BCM5411, BCM5421, BCM5461, BCM54616S, BCM5464,
238 BCM5481, BCM54810 and BCM5482 PHYs.
241 tristate "Cicada PHYs"
243 Currently supports the cis8204
246 tristate "Cortina EDC CDR 10G Ethernet PHY"
248 Currently supports the CS4340 phy.
251 tristate "Davicom PHYs"
253 Currently supports dm9161e and dm9131
256 tristate "Texas Instruments DP83848 PHY"
258 Supports the DP83848 PHY.
261 tristate "Texas Instruments DP83867 Gigabit PHY"
263 Currently supports the DP83867 PHY.
266 tristate "MDIO Bus/PHY emulation with fixed speed/link PHYs"
270 Adds the platform "fixed" MDIO Bus to cover the boards that use
271 PHYs that are not connected to the real MDIO bus.
273 Currently tested with mpc866ads and mpc8349e-mitx.
276 tristate "ICPlus PHYs"
278 Currently supports the IP175C and IP1001 PHYs.
280 config INTEL_XWAY_PHY
281 tristate "Intel XWAY PHYs"
283 Supports the Intel XWAY (former Lantiq) 11G and 22E PHYs.
284 These PHYs are marked as standalone chips under the names
285 PEF 7061, PEF 7071 and PEF 7072 or integrated into the Intel
286 SoCs xRX200, xRX300, xRX330, xRX350 and xRX550.
288 config LSI_ET1011C_PHY
289 tristate "LSI ET1011C PHY"
291 Supports the LSI ET1011C PHY.
294 tristate "Intel LXT PHYs"
296 Currently supports the lxt970, lxt971
299 tristate "Marvell PHYs"
301 Currently has a driver for the 88E1011S
303 config MARVELL_10G_PHY
304 tristate "Marvell Alaska 10Gbit PHYs"
306 Support for the Marvell Alaska MV88X3310 and compatible PHYs.
309 tristate "Amlogic Meson GXL Internal PHY"
310 depends on ARCH_MESON || COMPILE_TEST
312 Currently has a driver for the Amlogic Meson GXL Internal PHY
315 tristate "Micrel PHYs"
317 Supports the KSZ9021, VSC8201, KS8001 PHYs.
320 tristate "Microchip PHYs"
322 Supports the LAN88XX PHYs.
325 tristate "Microsemi PHYs"
327 Currently supports VSC8530, VSC8531, VSC8540 and VSC8541 PHYs
330 tristate "National Semiconductor PHYs"
332 Currently supports the DP83865 PHY.
335 tristate "Quality Semiconductor PHYs"
337 Currently supports the qs6612
340 tristate "Realtek PHYs"
342 Supports the Realtek 821x PHY.
347 Currently supports the LAN83C185, LAN8187 and LAN8700 PHYs
350 tristate "STMicroelectronics STe10Xp PHYs"
352 This is the driver for the STe100p and STe101p PHYs.
354 config TERANETICS_PHY
355 tristate "Teranetics PHYs"
357 Currently supports the Teranetics TN2020
360 tristate "Vitesse PHYs"
362 Currently supports the vsc8244
364 config XILINX_GMII2RGMII
365 tristate "Xilinx GMII2RGMII converter driver"
367 This driver support xilinx GMII to RGMII IP core it provides
368 the Reduced Gigabit Media Independent Interface(RGMII) between
369 Ethernet physical media devices and the Gigabit Ethernet controller.
373 config MICREL_KS8995MA
374 tristate "Micrel KS8995MA 5-ports 10/100 managed Ethernet switch"