]>
git.proxmox.com Git - mirror_ubuntu-jammy-kernel.git/blob - drivers/parisc/iosapic_private.h
1 /* SPDX-License-Identifier: GPL-2.0-or-later */
3 * Private structs/constants for PARISC IOSAPIC support
5 * Copyright (C) 2000 Hewlett Packard (Grant Grundler)
6 * Copyright (C) 2000,2003 Grant Grundler (grundler at parisc-linux.org)
7 * Copyright (C) 2002 Matthew Wilcox (willy at parisc-linux.org)
11 ** This file is private to iosapic driver.
12 ** If stuff needs to be used by another driver, move it to a common file.
14 ** WARNING: fields most data structures here are ordered to make sure
15 ** they pack nicely for 64-bit compilation. (ie sizeof(long) == 8)
20 ** Interrupt Routing Stuff
21 ** -----------------------
22 ** The interrupt routing table consists of entries derived from
23 ** MP Specification Draft 1.5. There is one interrupt routing
24 ** table per cell. N- and L-class consist of a single cell.
28 /* Entry Type 139 identifies an I/O SAPIC interrupt entry */
31 /* Entry Length 16 indicates entry is 16 bytes long */
35 ** Interrupt Type of 0 indicates a vectored interrupt,
36 ** all other values are reserved
42 ** Polarity of SAPIC I/O input signals:
47 ** Trigger mode of SAPIC I/O input signals:
49 ** 01 = Edge-triggered
51 ** 11 = Level-triggered
57 ** irq identifies PCI interrupt signal where
58 ** 0x0 corresponds to INT_A#,
59 ** 0x1 corresponds to INT_B#,
60 ** 0x2 corresponds to INT_C#
61 ** 0x3 corresponds to INT_D#
62 ** PCI device number where interrupt originates
66 /* Source Bus ID identifies the bus where interrupt signal comes from */
70 ** Segment ID is unique across a protection domain and
71 ** identifies a segment of PCI buses (reserved in
72 ** MP Specification Draft 1.5)
77 ** Destination I/O SAPIC INTIN# identifies the INTIN n pin
78 ** to which the signal is connected
80 u8 dest_iosapic_intin
;
83 ** Destination I/O SAPIC Address identifies the I/O SAPIC
84 ** to which the signal is connected
86 u64 dest_iosapic_addr
;
89 #define IRT_IOSAPIC_TYPE 139
90 #define IRT_IOSAPIC_LENGTH 16
92 #define IRT_VECTORED_INTR 0
94 #define IRT_PO_MASK 0x3
95 #define IRT_ACTIVE_HI 1
96 #define IRT_ACTIVE_LO 3
98 #define IRT_EL_MASK 0x3
99 #define IRT_EL_SHIFT 2
100 #define IRT_EDGE_TRIG 1
101 #define IRT_LEVEL_TRIG 3
103 #define IRT_IRQ_MASK 0x3
104 #define IRT_DEV_MASK 0x1f
105 #define IRT_DEV_SHIFT 2
107 #define IRT_IRQ_DEVNO_MASK ((IRT_DEV_MASK << IRT_DEV_SHIFT) | IRT_IRQ_MASK)
109 #ifdef SUPPORT_MULTI_CELL
111 struct iosapic_irt
*irt_next
; /* next routing table */
112 struct irt_entry
*irt_base
; /* intr routing table address */
113 size_t irte_count
; /* number of entries in the table */
114 size_t irte_size
; /* size (bytes) of each entry */
119 struct iosapic_info
*iosapic
; /* I/O SAPIC this vector is on */
120 struct irt_entry
*irte
; /* IRT entry */
121 u32 __iomem
*eoi_addr
; /* precalculate EOI reg address */
122 u32 eoi_data
; /* IA64: ? PA: swapped txn_data */
123 int txn_irq
; /* virtual IRQ number for processor */
124 ulong txn_addr
; /* IA64: id_eid PA: partial HPA */
125 u32 txn_data
; /* CPU interrupt bit */
126 u8 status
; /* status/flags */
127 u8 irqline
; /* INTINn(IRQ) */
131 struct iosapic_info
{
132 struct iosapic_info
* isi_next
; /* list of I/O SAPIC */
133 void __iomem
* addr
; /* remapped address */
134 unsigned long isi_hpa
; /* physical base address */
135 struct vector_info
* isi_vector
; /* IRdT (IRQ line) array */
136 int isi_num_vectors
; /* size of IRdT array */
137 int isi_status
; /* status/flags */
138 unsigned int isi_version
; /* DEBUG: data fr version reg */
145 ** PA risc does NOT have any local sapics. IA64 does.
146 ** PIB (Processor Interrupt Block) is handled by Astro or Dew (Stretch CEC).
148 ** PA: Get id_eid from IRT and hardcode PIB to 0xfeeNNNN0
149 ** Emulate the data on PAT platforms.
151 struct local_sapic_info
{
152 struct local_sapic_info
*lsi_next
; /* point to next CPU info */
153 int *lsi_cpu_id
; /* point to logical CPU id */
154 unsigned long *lsi_id_eid
; /* point to IA-64 CPU id */
155 int *lsi_status
; /* point to CPU status */
156 void *lsi_private
; /* point to special info */
160 ** "root" data structure which ties everything together.
161 ** Should always be able to start with sapic_root and locate
162 ** the desired information.
165 struct sapic_info
*si_next
; /* info is per cell */
166 int si_cellid
; /* cell id */
167 unsigned int si_status
; /* status */
168 char *si_pib_base
; /* intr blk base address */
169 local_sapic_info_t
*si_local_info
;
170 io_sapic_info_t
*si_io_info
;
171 extint_info_t
*si_extint_info
;/* External Intr info */