drivers/w1/slaves/Kconfig

   1 #
   2 # 1-wire slaves configuration
   3 #
   4
   5 menu "1-wire Slaves"
   6
   7 config W1_SLAVE_THERM
   8         tristate "Thermal family implementation"
   9         help
  10           Say Y here if you want to connect 1-wire thermal sensors to your
  11           wire.
  12
  13 config W1_SLAVE_SMEM
  14         tristate "Simple 64bit memory family implementation"
  15         help
  16           Say Y here if you want to connect 1-wire
  17           simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire.
  18
  19 config W1_SLAVE_DS2433
  20         tristate "4kb EEPROM family support (DS2433)"
  21         help
  22           Say Y here if you want to use a 1-wire
  23           4kb EEPROM family device (DS2433).
  24
  25 config W1_SLAVE_DS2433_CRC
  26         bool "Protect DS2433 data with a CRC16"
  27         depends on W1_SLAVE_DS2433
  28         select CRC16
  29         help
  30           Say Y here to protect DS2433 data with a CRC16.
  31           Each block has 30 bytes of data and a two byte CRC16.
  32           Full block writes are only allowed if the CRC is valid.
  33
  34 config W1_SLAVE_DS2760
  35         tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)"
  36         depends on W1
  37         help
  38           If you enable this you will have the DS2760 battery monitor
  39           chip support.
  40
  41           The battery monitor chip is used in many batteries/devices
  42           as the one who is responsible for charging/discharging/monitoring
  43           Li+ batteries.
  44
  45           If you are unsure, say N.
  46
  47 config W1_SLAVE_BQ27000
  48         tristate "BQ27000 slave support"
  49         depends on W1
  50         help
  51           Say Y here if you want to use a hdq
  52           bq27000 slave support.
  53
  54 endmenu