include/linux/regulator/consumer.h

   1 /*
   2  * consumer.h -- SoC Regulator consumer support.
   3  *
   4  * Copyright (C) 2007, 2008 Wolfson Microelectronics PLC.
   5  *
   6  * Author: Liam Girdwood <lrg@slimlogic.co.uk>
   7  *
   8  * This program is free software; you can redistribute it and/or modify
   9  * it under the terms of the GNU General Public License version 2 as
  10  * published by the Free Software Foundation.
  11  *
  12  * Regulator Consumer Interface.
  13  *
  14  * A Power Management Regulator framework for SoC based devices.
  15  * Features:-
  16  *   o Voltage and current level control.
  17  *   o Operating mode control.
  18  *   o Regulator status.
  19  *   o sysfs entries for showing client devices and status
  20  *
  21  * EXPERIMENTAL FEATURES:
  22  *   Dynamic Regulator operating Mode Switching (DRMS) - allows regulators
  23  *   to use most efficient operating mode depending upon voltage and load and
  24  *   is transparent to client drivers.
  25  *
  26  *   e.g. Devices x,y,z share regulator r. Device x and y draw 20mA each during
  27  *   IO and 1mA at idle. Device z draws 100mA when under load and 5mA when
  28  *   idling. Regulator r has > 90% efficiency in NORMAL mode at loads > 100mA
  29  *   but this drops rapidly to 60% when below 100mA. Regulator r has > 90%
  30  *   efficiency in IDLE mode at loads < 10mA. Thus regulator r will operate
  31  *   in normal mode for loads > 10mA and in IDLE mode for load <= 10mA.
  32  *
  33  */
  34
  35 #ifndef __LINUX_REGULATOR_CONSUMER_H_
  36 #define __LINUX_REGULATOR_CONSUMER_H_
  37
  38 struct device;
  39 struct notifier_block;
  40
  41 /*
  42  * Regulator operating modes.
  43  *
  44  * Regulators can run in a variety of different operating modes depending on
  45  * output load. This allows further system power savings by selecting the
  46  * best (and most efficient) regulator mode for a desired load.
  47  *
  48  * Most drivers will only care about NORMAL. The modes below are generic and
  49  * will probably not match the naming convention of your regulator data sheet
  50  * but should match the use cases in the datasheet.
  51  *
  52  * In order of power efficiency (least efficient at top).
  53  *
  54  *  Mode       Description
  55  *  FAST       Regulator can handle fast changes in it's load.
  56  *             e.g. useful in CPU voltage & frequency scaling where
  57  *             load can quickly increase with CPU frequency increases.
  58  *
  59  *  NORMAL     Normal regulator power supply mode. Most drivers will
  60  *             use this mode.
  61  *
  62  *  IDLE       Regulator runs in a more efficient mode for light
  63  *             loads. Can be used for devices that have a low power
  64  *             requirement during periods of inactivity. This mode
  65  *             may be more noisy than NORMAL and may not be able
  66  *             to handle fast load switching.
  67  *
  68  *  STANDBY    Regulator runs in the most efficient mode for very
  69  *             light loads. Can be used by devices when they are
  70  *             in a sleep/standby state. This mode is likely to be
  71  *             the most noisy and may not be able to handle fast load
  72  *             switching.
  73  *
  74  * NOTE: Most regulators will only support a subset of these modes. Some
  75  * will only just support NORMAL.
  76  *
  77  * These modes can be OR'ed together to make up a mask of valid register modes.
  78  */
  79
  80 #define REGULATOR_MODE_FAST                     0x1
  81 #define REGULATOR_MODE_NORMAL                   0x2
  82 #define REGULATOR_MODE_IDLE                     0x4
  83 #define REGULATOR_MODE_STANDBY                  0x8
  84
  85 /*
  86  * Regulator notifier events.
  87  *
  88  * UNDER_VOLTAGE  Regulator output is under voltage.
  89  * OVER_CURRENT   Regulator output current is too high.
  90  * REGULATION_OUT Regulator output is out of regulation.
  91  * FAIL           Regulator output has failed.
  92  * OVER_TEMP      Regulator over temp.
  93  * FORCE_DISABLE  Regulator forcibly shut down by software.
  94  * VOLTAGE_CHANGE Regulator voltage changed.
  95  * DISABLE        Regulator was disabled.
  96  *
  97  * NOTE: These events can be OR'ed together when passed into handler.
  98  */
  99
 100 #define REGULATOR_EVENT_UNDER_VOLTAGE           0x01
 101 #define REGULATOR_EVENT_OVER_CURRENT            0x02
 102 #define REGULATOR_EVENT_REGULATION_OUT          0x04
 103 #define REGULATOR_EVENT_FAIL                    0x08
 104 #define REGULATOR_EVENT_OVER_TEMP               0x10
 105 #define REGULATOR_EVENT_FORCE_DISABLE           0x20
 106 #define REGULATOR_EVENT_VOLTAGE_CHANGE          0x40
 107 #define REGULATOR_EVENT_DISABLE                 0x80
 108
 109 struct regulator;
 110
 111 /**
 112  * struct regulator_bulk_data - Data used for bulk regulator operations.
 113  *
 114  * @supply:   The name of the supply.  Initialised by the user before
 115  *            using the bulk regulator APIs.
 116  * @consumer: The regulator consumer for the supply.  This will be managed
 117  *            by the bulk API.
 118  *
 119  * The regulator APIs provide a series of regulator_bulk_() API calls as
 120  * a convenience to consumers which require multiple supplies.  This
 121  * structure is used to manage data for these calls.
 122  */
 123 struct regulator_bulk_data {
 124         const char *supply;
 125         struct regulator *consumer;
 126
 127         /* private: Internal use */
 128         int ret;
 129 };
 130
 131 #if defined(CONFIG_REGULATOR)
 132
 133 /* regulator get and put */
 134 struct regulator *__must_check regulator_get(struct device *dev,
 135                                              const char *id);
 136 struct regulator *__must_check regulator_get_exclusive(struct device *dev,
 137                                                        const char *id);
 138 void regulator_put(struct regulator *regulator);
 139
 140 /* regulator output control and status */
 141 int regulator_enable(struct regulator *regulator);
 142 int regulator_disable(struct regulator *regulator);
 143 int regulator_force_disable(struct regulator *regulator);
 144 int regulator_is_enabled(struct regulator *regulator);
 145 int regulator_disable_deferred(struct regulator *regulator, int ms);
 146
 147 int regulator_bulk_get(struct device *dev, int num_consumers,
 148                        struct regulator_bulk_data *consumers);
 149 int regulator_bulk_enable(int num_consumers,
 150                           struct regulator_bulk_data *consumers);
 151 int regulator_bulk_disable(int num_consumers,
 152                            struct regulator_bulk_data *consumers);
 153 int regulator_bulk_force_disable(int num_consumers,
 154                            struct regulator_bulk_data *consumers);
 155 void regulator_bulk_free(int num_consumers,
 156                          struct regulator_bulk_data *consumers);
 157
 158 int regulator_count_voltages(struct regulator *regulator);
 159 int regulator_list_voltage(struct regulator *regulator, unsigned selector);
 160 int regulator_is_supported_voltage(struct regulator *regulator,
 161                                    int min_uV, int max_uV);
 162 int regulator_set_voltage(struct regulator *regulator, int min_uV, int max_uV);
 163 int regulator_set_voltage_time(struct regulator *regulator,
 164                                int old_uV, int new_uV);
 165 int regulator_get_voltage(struct regulator *regulator);
 166 int regulator_sync_voltage(struct regulator *regulator);
 167 int regulator_set_current_limit(struct regulator *regulator,
 168                                int min_uA, int max_uA);
 169 int regulator_get_current_limit(struct regulator *regulator);
 170
 171 int regulator_set_mode(struct regulator *regulator, unsigned int mode);
 172 unsigned int regulator_get_mode(struct regulator *regulator);
 173 int regulator_set_optimum_mode(struct regulator *regulator, int load_uA);
 174
 175 /* regulator notifier block */
 176 int regulator_register_notifier(struct regulator *regulator,
 177                               struct notifier_block *nb);
 178 int regulator_unregister_notifier(struct regulator *regulator,
 179                                 struct notifier_block *nb);
 180
 181 /* driver data - core doesn't touch */
 182 void *regulator_get_drvdata(struct regulator *regulator);
 183 void regulator_set_drvdata(struct regulator *regulator, void *data);
 184
 185 #else
 186
 187 /*
 188  * Make sure client drivers will still build on systems with no software
 189  * controllable voltage or current regulators.
 190  */
 191 static inline struct regulator *__must_check regulator_get(struct device *dev,
 192         const char *id)
 193 {
 194         /* Nothing except the stubbed out regulator API should be
 195          * looking at the value except to check if it is an error
 196          * value. Drivers are free to handle NULL specifically by
 197          * skipping all regulator API calls, but they don't have to.
 198          * Drivers which don't, should make sure they properly handle
 199          * corner cases of the API, such as regulator_get_voltage()
 200          * returning 0.
 201          */
 202         return NULL;
 203 }
 204 static inline void regulator_put(struct regulator *regulator)
 205 {
 206 }
 207
 208 static inline int regulator_enable(struct regulator *regulator)
 209 {
 210         return 0;
 211 }
 212
 213 static inline int regulator_disable(struct regulator *regulator)
 214 {
 215         return 0;
 216 }
 217
 218 static inline int regulator_force_disable(struct regulator *regulator)
 219 {
 220         return 0;
 221 }
 222
 223 static inline int regulator_disable_deferred(struct regulator *regulator,
 224                                              int ms)
 225 {
 226         return 0;
 227 }
 228
 229 static inline int regulator_is_enabled(struct regulator *regulator)
 230 {
 231         return 1;
 232 }
 233
 234 static inline int regulator_bulk_get(struct device *dev,
 235                                      int num_consumers,
 236                                      struct regulator_bulk_data *consumers)
 237 {
 238         return 0;
 239 }
 240
 241 static inline int regulator_bulk_enable(int num_consumers,
 242                                         struct regulator_bulk_data *consumers)
 243 {
 244         return 0;
 245 }
 246
 247 static inline int regulator_bulk_disable(int num_consumers,
 248                                          struct regulator_bulk_data *consumers)
 249 {
 250         return 0;
 251 }
 252
 253 static inline int regulator_bulk_force_disable(int num_consumers,
 254                                         struct regulator_bulk_data *consumers)
 255 {
 256         return 0;
 257 }
 258
 259 static inline void regulator_bulk_free(int num_consumers,
 260                                        struct regulator_bulk_data *consumers)
 261 {
 262 }
 263
 264 static inline int regulator_set_voltage(struct regulator *regulator,
 265                                         int min_uV, int max_uV)
 266 {
 267         return 0;
 268 }
 269
 270 static inline int regulator_get_voltage(struct regulator *regulator)
 271 {
 272         return 0;
 273 }
 274
 275 static inline int regulator_set_current_limit(struct regulator *regulator,
 276                                              int min_uA, int max_uA)
 277 {
 278         return 0;
 279 }
 280
 281 static inline int regulator_get_current_limit(struct regulator *regulator)
 282 {
 283         return 0;
 284 }
 285
 286 static inline int regulator_set_mode(struct regulator *regulator,
 287         unsigned int mode)
 288 {
 289         return 0;
 290 }
 291
 292 static inline unsigned int regulator_get_mode(struct regulator *regulator)
 293 {
 294         return REGULATOR_MODE_NORMAL;
 295 }
 296
 297 static inline int regulator_set_optimum_mode(struct regulator *regulator,
 298                                         int load_uA)
 299 {
 300         return REGULATOR_MODE_NORMAL;
 301 }
 302
 303 static inline int regulator_register_notifier(struct regulator *regulator,
 304                               struct notifier_block *nb)
 305 {
 306         return 0;
 307 }
 308
 309 static inline int regulator_unregister_notifier(struct regulator *regulator,
 310                                 struct notifier_block *nb)
 311 {
 312         return 0;
 313 }
 314
 315 static inline void *regulator_get_drvdata(struct regulator *regulator)
 316 {
 317         return NULL;
 318 }
 319
 320 static inline void regulator_set_drvdata(struct regulator *regulator,
 321         void *data)
 322 {
 323 }
 324
 325 #endif
 326
 327 #endif