+ * @NL80211_ATTR_IFTYPE_EXT_CAPA: Nested attribute of the following attributes:
+ * %NL80211_ATTR_IFTYPE, %NL80211_ATTR_EXT_CAPA,
+ * %NL80211_ATTR_EXT_CAPA_MASK, to specify the extended capabilities per
+ * interface type.
+ *
+ * @NL80211_ATTR_MU_MIMO_GROUP_DATA: array of 24 bytes that defines a MU-MIMO
+ * groupID for monitor mode.
+ * The first 8 bytes are a mask that defines the membership in each
+ * group (there are 64 groups, group 0 and 63 are reserved),
+ * each bit represents a group and set to 1 for being a member in
+ * that group and 0 for not being a member.
+ * The remaining 16 bytes define the position in each group: 2 bits for
+ * each group.
+ * (smaller group numbers represented on most significant bits and bigger
+ * group numbers on least significant bits.)
+ * This attribute is used only if all interfaces are in monitor mode.
+ * Set this attribute in order to monitor packets using the given MU-MIMO
+ * groupID data.
+ * to turn off that feature set all the bits of the groupID to zero.
+ * @NL80211_ATTR_MU_MIMO_FOLLOW_MAC_ADDR: mac address for the sniffer to follow
+ * when using MU-MIMO air sniffer.
+ * to turn that feature off set an invalid mac address
+ * (e.g. FF:FF:FF:FF:FF:FF)
+ *
+ * @NL80211_ATTR_SCAN_START_TIME_TSF: The time at which the scan was actually
+ * started (u64). The time is the TSF of the BSS the interface that
+ * requested the scan is connected to (if available, otherwise this
+ * attribute must not be included).
+ * @NL80211_ATTR_SCAN_START_TIME_TSF_BSSID: The BSS according to which
+ * %NL80211_ATTR_SCAN_START_TIME_TSF is set.
+ * @NL80211_ATTR_MEASUREMENT_DURATION: measurement duration in TUs (u16). If
+ * %NL80211_ATTR_MEASUREMENT_DURATION_MANDATORY is not set, this is the
+ * maximum measurement duration allowed. This attribute is used with
+ * measurement requests. It can also be used with %NL80211_CMD_TRIGGER_SCAN
+ * if the scan is used for beacon report radio measurement.
+ * @NL80211_ATTR_MEASUREMENT_DURATION_MANDATORY: flag attribute that indicates
+ * that the duration specified with %NL80211_ATTR_MEASUREMENT_DURATION is
+ * mandatory. If this flag is not set, the duration is the maximum duration
+ * and the actual measurement duration may be shorter.
+ *
+ * @NL80211_ATTR_MESH_PEER_AID: Association ID for the mesh peer (u16). This is
+ * used to pull the stored data for mesh peer in power save state.
+ *