http://www.connecttech.com
For any questions or problems with this driver, please contact
- Stuart MacDonald at stuartm@connecttech.com
+ Connect Tech's Support Department at support@connecttech.com
-HandSpring Visor, Palm USB, and Clié USB driver
+HandSpring Visor, Palm USB, and Clié USB driver
- This driver works with all HandSpring USB, Palm USB, and Sony Clié USB
+ This driver works with all HandSpring USB, Palm USB, and Sony Clié USB
devices.
Only when the device tries to connect to the host, will the device show
the port to use for the HotSync transfer. The "Generic" port can be used
for other device communication, such as a PPP link.
- For some Sony Clié devices, /dev/ttyUSB0 must be used to talk to the
+ For some Sony Clié devices, /dev/ttyUSB0 must be used to talk to the
device. This is true for all OS version 3.5 devices, and most devices
that have had a flash upgrade to a newer version of the OS. See the
kernel system log for information on which is the correct port to use.
Current status:
The USA-18X, USA-28X, USA-19, USA-19W and USA-49W are supported and
- have been pretty throughly tested at various baud rates with 8-N-1
+ have been pretty thoroughly tested at various baud rates with 8-N-1
character settings. Other character lengths and parity setups are
presently untested.
together without hacking the adapter to set the line high.
The driver is smp safe. Performance with the driver is rather low when using
- it for transfering files. This is being worked on, but I would be willing to
+ it for transferring files. This is being worked on, but I would be willing to
accept patches. An urb queue or packet buffer would likely fit the bill here.
If you have any questions, problems, patches, feature requests, etc. you can
Parity N,E,O,M,S
Handshake None, Software (XON/XOFF), Hardware (CTSRTS,CTSDTR)*
Break Set and clear
- Line contrl Input/Output query and control **
+ Line control Input/Output query and control **
* Hardware input flow control is only enabled for firmware
levels above 2.06. Read source code comments describing Belkin
automatic hardware flow control.
TO DO List:
- -- Add true modem contol line query capability. Currently tracks the
+ -- Add true modem control line query capability. Currently tracks the
states reported by the interrupt and the states requested.
-- Add error reporting back to application for UART error conditions.
-- Add support for flush ioctls.