static void __init osk_init_smc91x(void)
{
+ u32 l;
+
if ((gpio_request(0, "smc_irq")) < 0) {
printk("Error requesting gpio 0 for smc91x irq\n");
return;
}
/* Check EMIFS wait states to fix errors with SMC_GET_PKT_HDR */
- EMIFS_CCS(1) |= 0x3;
+ l = omap_readl(EMIFS_CCS(1));
+ l |= 0x3;
+ omap_writel(l, EMIFS_CCS(1));
}
static void __init osk_init_cf(void)
static void __init osk_init(void)
{
+ u32 l;
+
/* Workaround for wrong CS3 (NOR flash) timing
* There are some U-Boot versions out there which configure
* wrong CS3 memory timings. This mainly leads to CRC
* or similar errors if you use NOR flash (e.g. with JFFS2)
*/
- if (EMIFS_CCS(3) != EMIFS_CS3_VAL)
- EMIFS_CCS(3) = EMIFS_CS3_VAL;
+ l = omap_readl(EMIFS_CCS(3));
+ if (l != EMIFS_CS3_VAL)
+ omap_writel(EMIFS_CS3_VAL, EMIFS_CCS(3));
osk_flash_resource.end = osk_flash_resource.start = omap_cs3_phys();
osk_flash_resource.end += SZ_32M - 1;
platform_add_devices(osk5912_devices, ARRAY_SIZE(osk5912_devices));
omap_board_config = osk_config;
omap_board_config_size = ARRAY_SIZE(osk_config);
- USB_TRANSCEIVER_CTRL_REG |= (3 << 1);
+
+ l = omap_readl(USB_TRANSCEIVER_CTRL);
+ l |= (3 << 1);
+ omap_writel(l, USB_TRANSCEIVER_CTRL);
/* irq for tps65010 chip */
/* bootloader effectively does: omap_cfg_reg(U19_1610_MPUIO1); */