/**
* it821x_set_pio_mode - set host controller for PIO mode
+ * @hwif: port
* @drive: drive
- * @pio: PIO mode number
*
* Tune the host to the desired PIO mode taking into the consideration
* the maximum PIO mode supported by the other device on the cable.
*/
-static void it821x_set_pio_mode(ide_drive_t *drive, const u8 pio)
+static void it821x_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
{
- ide_hwif_t *hwif = drive->hwif;
struct it821x_dev *itdev = ide_get_hwifdata(hwif);
ide_drive_t *pair = ide_get_pair_dev(drive);
+ const u8 pio = drive->pio_mode - XFER_PIO_0;
u8 unit = drive->dn & 1, set_pio = pio;
/* Spec says 89 ref driver uses 88 */
static struct ide_dma_ops it821x_pass_through_dma_ops = {
.dma_host_set = ide_dma_host_set,
.dma_setup = ide_dma_setup,
- .dma_exec_cmd = ide_dma_exec_cmd,
.dma_start = it821x_dma_start,
.dma_end = it821x_dma_end,
.dma_test_irq = ide_dma_test_irq,
- .dma_timeout = ide_dma_timeout,
.dma_lost_irq = ide_dma_lost_irq,
+ .dma_timer_expiry = ide_dma_sff_timer_expiry,
.dma_sff_read_status = ide_dma_sff_read_status,
};