This driver can also be built as a module. If so, the module will be
called hi8435.
+config HX711
+ tristate "AVIA HX711 ADC for weight cells"
+ depends on GPIOLIB
+ help
+ If you say yes here you get support for AVIA HX711 ADC which is used
+ for weigh cells
+
+ This driver uses two GPIOs, one acts as the clock and controls the
+ channel selection and gain, the other one is used for the measurement
+ data
+
+ Currently the raw value is read from the chip and delivered.
+ To get an actual weight one needs to subtract the
+ zero offset and multiply by a scale factor.
+ This should be done in userspace.
+
+ This driver can also be built as a module. If so, the module will be
+ called hx711.
+
config INA2XX_ADC
tristate "Texas Instruments INA2xx Power Monitors IIO driver"
depends on I2C && !SENSORS_INA2XX
This driver can also be built as a module. If so, the module will be
called ti-ads1015.
+config TI_ADS7950
+ tristate "Texas Instruments ADS7950 ADC driver"
+ depends on SPI
+ select IIO_BUFFER
+ select IIO_TRIGGERED_BUFFER
+ help
+ Say yes here to build support for Texas Instruments ADS7950, ADS7951,
+ ADS7952, ADS7953, ADS7954, ADS7955, ADS7956, ADS7957, ADS7958, ADS7959.
+ ADS7960, ADS7961.
+
+ To compile this driver as a module, choose M here: the
+ module will be called ti-ads7950.
+
config TI_ADS8688
tristate "Texas Instruments ADS8688"
depends on SPI && OF
config TI_AM335X_ADC
tristate "TI's AM335X ADC driver"
- depends on MFD_TI_AM335X_TSCADC
+ depends on MFD_TI_AM335X_TSCADC && HAS_DMA
select IIO_BUFFER
select IIO_KFIFO_BUF
help