modify_acceptable_latency("ipw2100", INFINITE_LATENCY);
-#ifdef ACPI_CSTATE_LIMIT_DEFINED
- if (priv->config & CFG_C3_DISABLED) {
- IPW_DEBUG_INFO(": Resetting C3 transitions.\n");
- acpi_set_cstate_limit(priv->cstate_limit);
- priv->config &= ~CFG_C3_DISABLED;
- }
-#endif
-
/* We have to signal any supplicant if we are disassociating */
if (associated)
wireless_send_event(priv->net_dev, SIOCGIWAP, &wrqu, NULL);
/* RF_KILL is now enabled (else we wouldn't be here) */
priv->status |= STATUS_RF_KILL_HW;
-#ifdef ACPI_CSTATE_LIMIT_DEFINED
- if (priv->config & CFG_C3_DISABLED) {
- IPW_DEBUG_INFO(": Resetting C3 transitions.\n");
- acpi_set_cstate_limit(priv->cstate_limit);
- priv->config &= ~CFG_C3_DISABLED;
- }
-#endif
-
/* Make sure the RF Kill check timer is running */
priv->stop_rf_kill = 0;
cancel_delayed_work(&priv->rf_kill);
u32 match, reg;
int j;
#endif
-#ifdef ACPI_CSTATE_LIMIT_DEFINED
- int limit;
-#endif
IPW_DEBUG_INFO(": PCI latency error detected at 0x%04zX.\n",
i * sizeof(struct ipw2100_status));
-#ifdef ACPI_CSTATE_LIMIT_DEFINED
- IPW_DEBUG_INFO(": Disabling C3 transitions.\n");
- limit = acpi_get_cstate_limit();
- if (limit > 2) {
- priv->cstate_limit = limit;
- acpi_set_cstate_limit(2);
- priv->config |= CFG_C3_DISABLED;
- }
-#endif
-
#ifdef IPW2100_DEBUG_C3
/* Halt the fimrware so we can get a good image */
write_register(priv->net_dev, IPW_REG_RESET_REG,
* ends up causing problems. So, we just handle
* the WX extensions through the ipw2100_ioctl interface */
- /* memset() puts everything to 0, so we only have explicitely set
+ /* memset() puts everything to 0, so we only have explicitly set
* those values that need to be something else */
/* If power management is turned on, default to AUTO mode */
switch (wrqu->power.flags & IW_POWER_MODE) {
case IW_POWER_ON: /* If not specified */
case IW_POWER_MODE: /* If set all mask */
- case IW_POWER_ALL_R: /* If explicitely state all */
+ case IW_POWER_ALL_R: /* If explicitly state all */
break;
default: /* Otherwise we don't support it */
IPW_DEBUG_WX("SET PM Mode: %X not supported.\n",