#define NCR5380_queue_command sun3scsi_queue_command
#define NCR5380_bus_reset sun3scsi_bus_reset
#define NCR5380_abort sun3scsi_abort
-#define NCR5380_show_info sun3scsi_show_info
#define NCR5380_info sun3scsi_info
#define NCR5380_dma_read_setup(instance, data, count) \
- sun3scsi_dma_setup(data, count, 0)
+ sun3scsi_dma_setup(instance, data, count, 0)
#define NCR5380_dma_write_setup(instance, data, count) \
- sun3scsi_dma_setup(data, count, 1)
+ sun3scsi_dma_setup(instance, data, count, 1)
#define NCR5380_dma_residual(instance) \
sun3scsi_dma_residual(instance)
#define NCR5380_dma_xfer_len(instance, cmd, phase) \
static int setup_hostid = -1;
module_param(setup_hostid, int, 0);
-/* #define RESET_BOOT */
-
-#define AFTER_RESET_DELAY (HZ/2)
-
/* ms to wait after hitting dma regs */
#define SUN3_DMA_DELAY 10
static unsigned char *sun3_scsi_regp;
static volatile struct sun3_dma_regs *dregs;
static struct sun3_udc_regs *udc_regs;
-static unsigned char *sun3_dma_orig_addr = NULL;
-static unsigned long sun3_dma_orig_count = 0;
-static int sun3_dma_active = 0;
-static unsigned long last_residual = 0;
-static struct Scsi_Host *default_instance;
+static unsigned char *sun3_dma_orig_addr;
+static unsigned long sun3_dma_orig_count;
+static int sun3_dma_active;
+static unsigned long last_residual;
/*
* NCR 5380 register access functions
}
#endif
-#ifdef RESET_BOOT
-static void sun3_scsi_reset_boot(struct Scsi_Host *instance)
-{
- unsigned long end;
-
- /*
- * Do a SCSI reset to clean up the bus during initialization. No
- * messing with the queues, interrupts, or locks necessary here.
- */
-
- printk( "Sun3 SCSI: resetting the SCSI bus..." );
-
- /* switch off SCSI IRQ - catch an interrupt without IRQ bit set else */
-// sun3_disable_irq( IRQ_SUN3_SCSI );
-
- /* get in phase */
- NCR5380_write( TARGET_COMMAND_REG,
- PHASE_SR_TO_TCR( NCR5380_read(STATUS_REG) ));
-
- /* assert RST */
- NCR5380_write( INITIATOR_COMMAND_REG, ICR_BASE | ICR_ASSERT_RST );
-
- /* The min. reset hold time is 25us, so 40us should be enough */
- udelay( 50 );
-
- /* reset RST and interrupt */
- NCR5380_write( INITIATOR_COMMAND_REG, ICR_BASE );
- NCR5380_read( RESET_PARITY_INTERRUPT_REG );
-
- for( end = jiffies + AFTER_RESET_DELAY; time_before(jiffies, end); )
- barrier();
-
- /* switch on SCSI IRQ again */
-// sun3_enable_irq( IRQ_SUN3_SCSI );
-
- printk( " done\n" );
-}
-#endif
-
// safe bits for the CSR
#define CSR_GOOD 0x060f
-static irqreturn_t scsi_sun3_intr(int irq, void *dummy)
+static irqreturn_t scsi_sun3_intr(int irq, void *dev)
{
+ struct Scsi_Host *instance = dev;
unsigned short csr = dregs->csr;
int handled = 0;
#endif
if(csr & ~CSR_GOOD) {
- if(csr & CSR_DMA_BUSERR) {
- printk("scsi%d: bus error in dma\n", default_instance->host_no);
- }
-
- if(csr & CSR_DMA_CONFLICT) {
- printk("scsi%d: dma conflict\n", default_instance->host_no);
- }
+ if (csr & CSR_DMA_BUSERR)
+ shost_printk(KERN_ERR, instance, "bus error in DMA\n");
+ if (csr & CSR_DMA_CONFLICT)
+ shost_printk(KERN_ERR, instance, "DMA conflict\n");
handled = 1;
}
if(csr & (CSR_SDB_INT | CSR_DMA_INT)) {
- NCR5380_intr(irq, dummy);
+ NCR5380_intr(irq, dev);
handled = 1;
}
return IRQ_RETVAL(handled);
}
-/*
- * Debug stuff - to be called on NMI, or sysrq key. Use at your own risk;
- * reentering NCR5380_print_status seems to have ugly side effects
- */
-
-/* this doesn't seem to get used at all -- sam */
-#if 0
-void sun3_sun3_debug (void)
-{
- unsigned long flags;
-
- if (default_instance) {
- local_irq_save(flags);
- NCR5380_print_status(default_instance);
- local_irq_restore(flags);
- }
-}
-#endif
-
-
/* sun3scsi_dma_setup() -- initialize the dma controller for a read/write */
-static unsigned long sun3scsi_dma_setup(void *data, unsigned long count, int write_flag)
+static unsigned long sun3scsi_dma_setup(struct Scsi_Host *instance,
+ void *data, unsigned long count, int write_flag)
{
void *addr;
dregs->csr |= CSR_FIFO;
if(dregs->fifo_count != count) {
- printk("scsi%d: fifo_mismatch %04x not %04x\n",
- default_instance->host_no, dregs->fifo_count,
- (unsigned int) count);
- NCR5380_dprint(NDEBUG_DMA, default_instance);
+ shost_printk(KERN_ERR, instance, "FIFO mismatch %04x not %04x\n",
+ dregs->fifo_count, (unsigned int) count);
+ NCR5380_dprint(NDEBUG_DMA, instance);
}
/* setup udc */
}
-#ifndef SUN3_SCSI_VME
-static inline unsigned long sun3scsi_dma_count(struct Scsi_Host *instance)
-{
- unsigned short resid;
-
- dregs->udc_addr = 0x32;
- udelay(SUN3_DMA_DELAY);
- resid = dregs->udc_data;
- udelay(SUN3_DMA_DELAY);
- resid *= 2;
-
- return (unsigned long) resid;
-}
-#endif
-
static inline unsigned long sun3scsi_dma_residual(struct Scsi_Host *instance)
{
return last_residual;
}
}
- count = sun3scsi_dma_count(default_instance);
+ dregs->udc_addr = 0x32;
+ udelay(SUN3_DMA_DELAY);
+ count = 2 * dregs->udc_data;
+ udelay(SUN3_DMA_DELAY);
fifo = dregs->fifo_count;
last_residual = fifo;
static struct scsi_host_template sun3_scsi_template = {
.module = THIS_MODULE,
.proc_name = DRV_MODULE_NAME,
- .show_info = sun3scsi_show_info,
.name = SUN3_SCSI_NAME,
.info = sun3scsi_info,
.queuecommand = sun3scsi_queue_command,
- .eh_abort_handler = sun3scsi_abort,
- .eh_bus_reset_handler = sun3scsi_bus_reset,
+ .eh_abort_handler = sun3scsi_abort,
+ .eh_bus_reset_handler = sun3scsi_bus_reset,
.can_queue = 16,
.this_id = 7,
.sg_tablesize = SG_NONE,
.cmd_per_lun = 2,
- .use_clustering = DISABLE_CLUSTERING
+ .use_clustering = DISABLE_CLUSTERING,
+ .cmd_size = NCR5380_CMD_SIZE,
};
static int __init sun3_scsi_probe(struct platform_device *pdev)
error = -ENOMEM;
goto fail_alloc;
}
- default_instance = instance;
instance->io_port = (unsigned long)ioaddr;
instance->irq = irq->start;
host_flags |= setup_use_tagged_queuing > 0 ? FLAG_TAGGED_QUEUING : 0;
#endif
- NCR5380_init(instance, host_flags);
+ error = NCR5380_init(instance, host_flags);
+ if (error)
+ goto fail_init;
error = request_irq(instance->irq, scsi_sun3_intr, 0,
"NCR5380", instance);
dregs->ivect = VME_DATA24 | (instance->irq & 0xff);
#endif
-#ifdef RESET_BOOT
- sun3_scsi_reset_boot(instance);
-#endif
+ NCR5380_maybe_reset_bus(instance);
error = scsi_add_host(instance, NULL);
if (error)
free_irq(instance->irq, instance);
fail_irq:
NCR5380_exit(instance);
+fail_init:
scsi_host_put(instance);
fail_alloc:
if (udc_regs)
projects / mirror_ubuntu-zesty-kernel.git / blobdiff