* value of the line status flags from the port
* @shadowMSR: Last received state of the modem status register, holds
* the value of the modem status received from the port
- * @rcv_flush: Flag indicating that a receive flush has occured on
+ * @rcv_flush: Flag indicating that a receive flush has occurred on
* the hardware.
* @xmit_flush: Flag indicating that a transmit flush has been processed by
* the hardware.
* includes the size (excluding header) of URBs that have been submitted but
* have not yet been sent to to the device, and bytes that have been sent out
* of the port but not yet reported sent by the "xmit_empty" messages (which
- * indicate the number of bytes sent each time they are recieved, despite the
+ * indicate the number of bytes sent each time they are received, despite the
* misleading name).
* - Starts at zero when port is initialised.
* - is incremented by the size of the data to be written (no headers)
/* although the USB side is now empty, the UART itself may
* still be pushing characters out over the line, so we have to
* wait testing the actual line status until the lines change
- * indicating that the data is done transfering. */
+ * indicating that the data is done transferring. */
/* FIXME: slow this polling down so it doesn't run the USB bus flat out
* if it actually has to spend any time in this loop (which it normally
* doesn't because the buffer is nearly empty) */
return 0;
} else if (port_extra->tx_pending_bytes >= QT2_FIFO_DEPTH) {
/* buffer is full (==). > should not occur, but would indicate
- * that an overflow had occured */
+ * that an overflow had occurred */
dbg("%s(): port transmit buffer is full!", __func__);
/* schedule_work(&port->work); commented in vendor driver */
return 0;
* reduce the free space count by the size of the dispatched write.
* When a "transmit empty" message comes back up the USB read stream,
* we decrement the count by the number of bytes reported sent, thus
- * keeping track of the difference between sent and recieved bytes.
+ * keeping track of the difference between sent and received bytes.
*/
room = (QT2_FIFO_DEPTH - port_extra->tx_pending_bytes);
}
}
-/** @brief Retreive the value of a register from the device
+/** @brief Retrieve the value of a register from the device
*
* Issues a GET_REGISTER vendor-spcific request over the USB control
* pipe to obtain a value back from a specific register on a specific