#define ETH_P_LOOP 0x0060 /* Ethernet Loopback packet */
#define ETH_P_PUP 0x0200 /* Xerox PUP packet */
#define ETH_P_PUPAT 0x0201 /* Xerox PUP Addr Trans packet */
+#define ETH_P_TSN 0x22F0 /* TSN (IEEE 1722) packet */
#define ETH_P_IP 0x0800 /* Internet Protocol packet */
#define ETH_P_X25 0x0805 /* CCITT X.25 */
#define ETH_P_ARP 0x0806 /* Address Resolution packet */
#define ETH_P_BPQ 0x08FF /* G8BPQ AX.25 Ethernet Packet [ NOT AN OFFICIALLY REGISTERED ID ] */
#define ETH_P_IEEEPUP 0x0a00 /* Xerox IEEE802.3 PUP packet */
#define ETH_P_IEEEPUPAT 0x0a01 /* Xerox IEEE802.3 PUP Addr Trans packet */
+#define ETH_P_BATMAN 0x4305 /* B.A.T.M.A.N.-Advanced packet [ NOT AN OFFICIALLY REGISTERED ID ] */
#define ETH_P_DEC 0x6000 /* DEC Assigned proto */
#define ETH_P_DNA_DL 0x6001 /* DEC DNA Dump/Load */
#define ETH_P_DNA_RC 0x6002 /* DEC DNA Remote Console */
#define ETH_P_SLOW 0x8809 /* Slow Protocol. See 802.3ad 43B */
#define ETH_P_WCCP 0x883E /* Web-cache coordination protocol
* defined in draft-wilson-wrec-wccp-v2-00.txt */
-#define ETH_P_PPP_DISC 0x8863 /* PPPoE discovery messages */
-#define ETH_P_PPP_SES 0x8864 /* PPPoE session messages */
#define ETH_P_MPLS_UC 0x8847 /* MPLS Unicast traffic */
#define ETH_P_MPLS_MC 0x8848 /* MPLS Multicast traffic */
#define ETH_P_ATMMPOA 0x884c /* MultiProtocol Over ATM */
+#define ETH_P_PPP_DISC 0x8863 /* PPPoE discovery messages */
+#define ETH_P_PPP_SES 0x8864 /* PPPoE session messages */
+#define ETH_P_LINK_CTL 0x886c /* HPNA, wlan link local tunnel */
#define ETH_P_ATMFATE 0x8884 /* Frame-based ATM Transport
* over Ethernet
*/
#define ETH_P_PAE 0x888E /* Port Access Entity (IEEE 802.1X) */
#define ETH_P_AOE 0x88A2 /* ATA over Ethernet */
+#define ETH_P_8021AD 0x88A8 /* 802.1ad Service VLAN */
+#define ETH_P_802_EX1 0x88B5 /* 802.1 Local Experimental 1. */
#define ETH_P_TIPC 0x88CA /* TIPC */
+#define ETH_P_MACSEC 0x88E5 /* 802.1ae MACsec */
+#define ETH_P_8021AH 0x88E7 /* 802.1ah Backbone Service Tag */
+#define ETH_P_MVRP 0x88F5 /* 802.1Q MVRP */
#define ETH_P_1588 0x88F7 /* IEEE 1588 Timesync */
+#define ETH_P_PRP 0x88FB /* IEC 62439-3 PRP/HSRv0 */
#define ETH_P_FCOE 0x8906 /* Fibre Channel over Ethernet */
+#define ETH_P_TDLS 0x890D /* TDLS */
#define ETH_P_FIP 0x8914 /* FCoE Initialization Protocol */
+#define ETH_P_80221 0x8917 /* IEEE 802.21 Media Independent Handover Protocol */
+#define ETH_P_HSR 0x892F /* IEC 62439-3 HSRv1 */
+#define ETH_P_LOOPBACK 0x9000 /* Ethernet loopback packet, per IEEE 802.3 */
+#define ETH_P_QINQ1 0x9100 /* deprecated QinQ VLAN [ NOT AN OFFICIALLY REGISTERED ID ] */
+#define ETH_P_QINQ2 0x9200 /* deprecated QinQ VLAN [ NOT AN OFFICIALLY REGISTERED ID ] */
+#define ETH_P_QINQ3 0x9300 /* deprecated QinQ VLAN [ NOT AN OFFICIALLY REGISTERED ID ] */
#define ETH_P_EDSA 0xDADA /* Ethertype DSA [ NOT AN OFFICIALLY REGISTERED ID ] */
+#define ETH_P_AF_IUCV 0xFBFB /* IBM af_iucv [ NOT AN OFFICIALLY REGISTERED ID ] */
+
+#define ETH_P_802_3_MIN 0x0600 /* If the value in the ethernet type is less than this value
+ * then the frame is Ethernet II. Else it is 802.3 */
/*
* Non DIX types. Won't clash for 1500 types.
#define ETH_P_WAN_PPP 0x0007 /* Dummy type for WAN PPP frames*/
#define ETH_P_PPP_MP 0x0008 /* Dummy type for PPP MP frames */
#define ETH_P_LOCALTALK 0x0009 /* Localtalk pseudo type */
-#define ETH_P_CAN 0x000C /* Controller Area Network */
+#define ETH_P_CAN 0x000C /* CAN: Controller Area Network */
+#define ETH_P_CANFD 0x000D /* CANFD: CAN flexible data rate*/
#define ETH_P_PPPTALK 0x0010 /* Dummy type for Atalk over PPP*/
#define ETH_P_TR_802_2 0x0011 /* 802.2 frames */
#define ETH_P_MOBITEX 0x0015 /* Mobitex (kaz@cafe.net) */
#define ETH_P_TRAILER 0x001C /* Trailer switch tagging */
#define ETH_P_PHONET 0x00F5 /* Nokia Phonet frames */
#define ETH_P_IEEE802154 0x00F6 /* IEEE802.15.4 frame */
+#define ETH_P_CAIF 0x00F7 /* ST-Ericsson CAIF protocol */
+#define ETH_P_XDSA 0x00F8 /* Multiplexed DSA protocol */
/*
* This is an Ethernet frame header.
__be16 h_proto; /* packet type ID field */
} __attribute__((packed));
-#ifdef __KERNEL__
-#include <linux/skbuff.h>
-
-static inline struct ethhdr *eth_hdr(const struct sk_buff *skb)
-{
- return (struct ethhdr *)skb_mac_header(skb);
-}
-
-int eth_header_parse(const struct sk_buff *skb, unsigned char *haddr);
-
-#ifdef CONFIG_SYSCTL
-extern struct ctl_table ether_table[];
-#endif
-
-extern ssize_t sysfs_format_mac(char *buf, const unsigned char *addr, int len);
-
-/*
- * Display a 6 byte device address (MAC) in a readable format.
- */
-extern char *print_mac(char *buf, const unsigned char *addr);
-#define MAC_FMT "%02x:%02x:%02x:%02x:%02x:%02x"
-#define MAC_BUF_SIZE 18
-#define DECLARE_MAC_BUF(var) char var[MAC_BUF_SIZE] __maybe_unused
-
-#endif
-#endif /* _LINUX_IF_ETHER_H */
+#endif /* _LINUX_IF_ETHER_H */
projects / mirror_iproute2.git / blobdiff