which is done within the script "scripts/setlocalversion".)
+config HAVE_KERNEL_GZIP
+ bool
+
+config HAVE_KERNEL_BZIP2
+ bool
+
+config HAVE_KERNEL_LZMA
+ bool
+
+choice
+ prompt "Kernel compression mode"
+ default KERNEL_GZIP
+ depends on HAVE_KERNEL_GZIP || HAVE_KERNEL_BZIP2 || HAVE_KERNEL_LZMA
+ help
+ The linux kernel is a kind of self-extracting executable.
+ Several compression algorithms are available, which differ
+ in efficiency, compression and decompression speed.
+ Compression speed is only relevant when building a kernel.
+ Decompression speed is relevant at each boot.
+
+ If you have any problems with bzip2 or lzma compressed
+ kernels, mail me (Alain Knaff) <alain@knaff.lu>. (An older
+ version of this functionality (bzip2 only), for 2.4, was
+ supplied by Christian Ludwig)
+
+ High compression options are mostly useful for users, who
+ are low on disk space (embedded systems), but for whom ram
+ size matters less.
+
+ If in doubt, select 'gzip'
+
+config KERNEL_GZIP
+ bool "Gzip"
+ depends on HAVE_KERNEL_GZIP
+ help
+ The old and tried gzip compression. Its compression ratio is
+ the poorest among the 3 choices; however its speed (both
+ compression and decompression) is the fastest.
+
+config KERNEL_BZIP2
+ bool "Bzip2"
+ depends on HAVE_KERNEL_BZIP2
+ help
+ Its compression ratio and speed is intermediate.
+ Decompression speed is slowest among the three. The kernel
+ size is about 10% smaller with bzip2, in comparison to gzip.
+ Bzip2 uses a large amount of memory. For modern kernels you
+ will need at least 8MB RAM or more for booting.
+
+config KERNEL_LZMA
+ bool "LZMA"
+ depends on HAVE_KERNEL_LZMA
+ help
+ The most recent compression algorithm.
+ Its ratio is best, decompression speed is between the other
+ two. Compression is slowest. The kernel size is about 33%
+ smaller with LZMA in comparison to gzip.
+
+endchoice
+
config SWAP
bool "Support for paging of anonymous memory (swap)"
depends on MMU && BLOCK
config CPUSETS
bool "Cpuset support"
- depends on SMP && CGROUPS
+ depends on CGROUPS
help
This option will let you create and manage CPUSETs which
allow dynamically partitioning a system into sets of CPUs and
is disabled by boot option, this will be automatically disabled and
there will be no overhead from this. Even when you set this config=y,
if boot option "noswapaccount" is set, swap will not be accounted.
+ Now, memory usage of swap_cgroup is 2 bytes per entry. If swap page
+ size is 4096bytes, 512k per 1Gbytes of swap.
endif # CGROUPS
source "arch/Kconfig"
+config SLOW_WORK
+ default n
+ bool "Enable slow work thread pool"
+ help
+ The slow work thread pool provides a number of dynamically allocated
+ threads that can be used by the kernel to perform operations that
+ take a relatively long time.
+
+ An example of this would be CacheFiles doing a path lookup followed
+ by a series of mkdirs and a create call, all of which have to touch
+ disk.
+
endmenu # General setup
config HAVE_GENERIC_DMA_COHERENT
config RT_MUTEXES
boolean
- select PLIST
config BASE_SMALL
int