systemctl enable snap.frr.ospf6d.service
The daemons are: `ripd`, `ripngd`, `ospfd`, `ospf6d`, `isisd`, `bgpd`,
-`pimd`, `zebra`
+`pimd`, `ldpd`, `eigrpd`, `babeld`, `nhrpd`, `bfdd`, `zebra`
Commands defined by this snap
-----------------------------
- `frr.readme`:
Returns this document `cat README_usage.md`
- `frr.set`:
- Allows to enable `FPM` module. See FPM section below
+ Allows to enable `FPM` and/or disable RPKIi module. See Module section below
and for debugging defined at this time (May get removed later - do not
depend on them). These are mainly intended to debug the Snap
- `frr.pimd-debug`:
Starts pimd daemon in foreground
- `frr.ldpd-debug`:
- Starts ldpd daemon in foreground
+ Starts ldpd daemon in foreground
+- `frr.nhrpd-debug`:
+ Starts nhrpd daemon in foreground
+- `frr.babeld-debug`:
+ Starts babeld daemon in foreground
+- `frr.eigrpd-debug`:
+ Starts eigrpd daemon in foreground
+- `frr.pbrd-debug`:
+ Starts pbrd daemon in foreground
+- `frr.staticd-debug`:
+ Starts staticd daemon in foreground
+- `frr.bfdd-debug`:
+ Starts bfdd daemon in foreground
MPLS (LDP)
----------
These settings require either a reboot or a manual configuration with
`sysctl` as well.
-FPM Module
+Modules
----------
-The `frr.set` allows to turn FPM module on or off.
+The `frr.set` allows to turn FPM module ond the RPKI module on or off.
frr.set fpm {disable|protobuf|netlink}
- Disables FPM or enables FPM with selected mode
+ Disables FPM or enables FPM with selected mode (default: disabled)
By default, the FPM module is disabled, but installed with netlink and
protobuf support. To enable the FPM module, use the `frr.set fpm protobuf`
for the next restart of zebra. Please reboot or restart zebra after
changing the mode to become effective.
+ frr.set rpki {enable|disable}
+
+ Disables or enables BGP RPKI (default: enabled)
+
+By default, the RPKI module is enabled. To disable the RPKI module
+use the `frr.set rpki disable` command. The command will only enable
+the module after the next restart of the bgp daemon. Please reboot or
+restart bgpd after changing the mode to become effective.
+(Normally, there is no need to disable the module as it has no effect
+if there are no RPKI configurations in BGP)
+
FAQ
---
- frr.vtysh displays `--MORE--` on long output. How to suppress this?
- Define `VTYSH_PAGER` to `cat` (default is `more`). (Ie add
`export VTYSH_PAGER=cat` to the end of your `.profile`)
-- ospfd / ospf6d are not running after installation
+- bfdd / ospfd / ospf6d / nhrpd are not running after installation
- Installing a new snap starts the daemons, but at this time they
may not have the required privileged access. Make sure you
issue the `snap connect` command as given above (can be verified