ui: track how much decoded data we consumed when doing SASL encoding

ui: track how much decoded data we consumed when doing SASL encoding

When we encode data for writing with SASL, we encode the entire pending output
buffer. The subsequent write, however, may not be able to send the full encoded
data in one go though, particularly with a slow network. So we delay setting the
output buffer offset back to zero until all the SASL encoded data is sent.

Between encoding the data and completing sending of the SASL encoded data,
however, more data might have been placed on the pending output buffer. So it
is not valid to set offset back to zero. Instead we must keep track of how much
data we consumed during encoding and subtract only that amount.

With the current bug we would be throwing away some pending data without having
sent it at all. By sheer luck this did not previously cause any serious problem
because appending data to the send buffer is always an atomic action, so we
only ever throw away complete RFB protocol messages. In the case of frame buffer
updates we'd catch up fairly quickly, so no obvious problem was visible.

Signed-off-by: Daniel P. Berrange <berrange@redhat.com>
Reviewed-by: Darren Kenny <darren.kenny@oracle.com>
Reviewed-by: Marc-André Lureau <marcandre.lureau@redhat.com>
Message-id: 20171218191228.31018-6-berrange@redhat.com
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>