Define the behaviour when an error is encountered. (Either ignore
errors and just mark the file system erroneous and continue, or remount
the file system read-only, or panic and halt the system.) The default is
set in the filesystem superblock, and can be changed using tune2fs(8).
---- end of quote ----
However EXT3_ERRORS_CONTINUE is not read from the superblock, and thus
ERRORS_CONT is not saved on the sbi->s_mount_opt. It leads to the incorrect
handle of errors on ext3.
Then we've checked corresponding code in ext2 and discovered that it is buggy
as well:
- EXT2_ERRORS_CONTINUE is not read from the superblock (the same);
- parse_option() does not clean the alternative values and thus something
like (ERRORS_CONT|ERRORS_RO) can be set;
- if options are omitted, parse_option() does not set any of these options.
Therefore it is possible to set any combination of these options on the ext2:
- none of them may be set: EXT2_ERRORS_CONTINUE on superblock / empty mount
options;
- any of them may be set using mount options;
- 2 any options may be set: by using EXT2_ERRORS_RO/EXT2_ERRORS_PANIC on the
superblock and other value in mount options;
- and finally all three options may be set by adding third option in remount.
Currently ext2 uses these values only in ext2_error() and it is not leading to
any noticeable troubles. However somebody may be discouraged when he will try
to workaround EXT2_ERRORS_PANIC on the superblock by using errors=continue in
mount options.
This patch:
EXT3_ERRORS_CONTINUE should be taken from the superblock as default value for
error behaviour.