Merge branch 'stmmac-add-dwmac-sun8i-ethernet-driver'

Merge branch 'stmmac-add-dwmac-sun8i-ethernet-driver'

Corentin Labbe says:

====================
net-next: stmmac: add dwmac-sun8i ethernet driver

This patch series add the driver for dwmac-sun8i which handle the Ethernet MAC
present on Allwinner H3/H5/A83T/A64 SoCs.

This driver is the continuation of the sun8i-emac driver.
During the development, it appeared that in fact the hardware was a modified
version of some dwmac.
So the driver is now written as a glue driver for stmmac.

It supports 10/100/1000 Mbit/s speed with half/full duplex.
It can use an internal PHY (MII 10/100) or an external PHY
via RGMII/RMII.

This patch series enable the driver only for the H3/A64/H5 SoC since A83T
doesn't have the necessary clocks present in mainline.

The driver have been tested on the following boards:
- H3 Orange PI PC, BananaPI-M2+
- A64 Pine64, BananaPi-M64
- A83T BananaPI-M3

The first two patchs are some mandatory changes for letting dwmac-sun8i be used.
The following three patchs add the driver and its documentation.
The remaining are DT patch enabling it.

Regards
Corentin Labbe

Changes since v5:
- Added DT patch for NanoPi neo
- Use the new adjust_link variables (speedxxx/speedmask)
- Made the timeout of readl_poll_timeout from 10 to 100ms
- Fix sun8i_unpower_phy that could be called twice
- Replace phy by phy-handle in doc/dwmac-sun8i.txt

Changes since v4:
- Re-ordered by alphabetical order some DT nodes
- Simplified power/unpower_phy functions by testing the use of internal_phy
- Added a patch for adding dwmac-sun8i to arm64 defconfig
- Fix a typo in sun50i-a64-system-controller (wrongly used sun8i)
- Reworked uc/mc filter address setting

Changes since v3:
- Renamed tx-delay/rx-delay to tx-delay-ps/rx-delay-ps
- fix syscon compatible example
- Changed parameter type for setup() function
- Dropped some DT patchs for boards which I could not test further

Changes since v2:
- corrected order of syscon compatible
- added compatible = "ethernet-phy-ieee802.3-c22 to PHY
- added set_mac function

Changes since v1:
- added TX/RX delay units
- splitted syscon documentation in its own patch
- regulator is now disabled after clk_prepare_enable(gmac->tx_clk) error
- Fixed a memory leak on mac_device_info
- Use now generic pin config for all DT stuff
- CONFIG_DWMAC_SUN8I is now set to y in defconfigs
====================

Signed-off-by: David S. Miller <davem@davemloft.net>