P1023 external IRQ[4:6, 11] are not pin out, but the interrupts are
utilized by the PCIe controllers. As they are not exposed as pins we
need to set them as active-high (internal to the SoC these interrupts
are pulled down).
IRQs[0:3,7:10] are pulled up on the board so we have them set as
active-low.
Signed-off-by: Roy Zang <tie-fei.zang@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
+ /* IRQ[0:3] are pulled up on board, set to active-low */
interrupt-map = <
/* IDSEL 0x0 */
0000 0 0 1 &mpic 0 1
interrupt-map = <
/* IDSEL 0x0 */
0000 0 0 1 &mpic 0 1
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
+ /*
+ * IRQ[4:6] only for PCIe, set to active-high,
+ * IRQ[7] is pulled up on board, set to active-low
+ */
interrupt-map = <
/* IDSEL 0x0 */
interrupt-map = <
/* IDSEL 0x0 */
- 0000 0 0 1 &mpic 4 1
- 0000 0 0 2 &mpic 5 1
- 0000 0 0 3 &mpic 6 1
+ 0000 0 0 1 &mpic 4 2
+ 0000 0 0 2 &mpic 5 2
+ 0000 0 0 3 &mpic 6 2
0000 0 0 4 &mpic 7 1
>;
ranges = <0x2000000 0x0 0xa0000000
0000 0 0 4 &mpic 7 1
>;
ranges = <0x2000000 0x0 0xa0000000
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
interrupt-parent = <&mpic>;
interrupts = <16 2>;
interrupt-map-mask = <0xf800 0 0 7>;
+ /*
+ * IRQ[8:10] are pulled up on board, set to active-low
+ * IRQ[11] only for PCIe, set to active-high,
+ */
interrupt-map = <
/* IDSEL 0x0 */
0000 0 0 1 &mpic 8 1
0000 0 0 2 &mpic 9 1
0000 0 0 3 &mpic 10 1
interrupt-map = <
/* IDSEL 0x0 */
0000 0 0 1 &mpic 8 1
0000 0 0 2 &mpic 9 1
0000 0 0 3 &mpic 10 1
>;
ranges = <0x2000000 0x0 0x80000000
0x2000000 0x0 0x80000000
>;
ranges = <0x2000000 0x0 0x80000000
0x2000000 0x0 0x80000000