Since dev->power.should_wakeup bit is used by the PCI core to
decide whether the device should wake up the system from sleep
states, set/unset this bit whenever WOL is enabled/disabled using
e1000_set_wol(). Accordingly, use device_can_wakeup() for checking
if wake-up is supported by the device.
Signed-off-by: "Rafael J. Wysocki" <rjw@sisk.pl>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
/* this function will set ->supported = 0 and return 1 if wol is not
* supported by this hardware */
/* this function will set ->supported = 0 and return 1 if wol is not
* supported by this hardware */
- if (e1000_wol_exclusion(adapter, wol))
+ if (e1000_wol_exclusion(adapter, wol) ||
+ !device_can_wakeup(&adapter->pdev->dev))
return;
/* apply any specific unsupported masks here */
return;
/* apply any specific unsupported masks here */
if (wol->wolopts & (WAKE_PHY | WAKE_ARP | WAKE_MAGICSECURE))
return -EOPNOTSUPP;
if (wol->wolopts & (WAKE_PHY | WAKE_ARP | WAKE_MAGICSECURE))
return -EOPNOTSUPP;
- if (e1000_wol_exclusion(adapter, wol))
+ if (e1000_wol_exclusion(adapter, wol) ||
+ !device_can_wakeup(&adapter->pdev->dev))
return wol->wolopts ? -EOPNOTSUPP : 0;
switch (hw->device_id) {
return wol->wolopts ? -EOPNOTSUPP : 0;
switch (hw->device_id) {
if (wol->wolopts & WAKE_MAGIC)
adapter->wol |= E1000_WUFC_MAG;
if (wol->wolopts & WAKE_MAGIC)
adapter->wol |= E1000_WUFC_MAG;
+ device_set_wakeup_enable(&adapter->pdev->dev, adapter->wol);
+
/* initialize the wol settings based on the eeprom settings */
adapter->wol = adapter->eeprom_wol;
/* initialize the wol settings based on the eeprom settings */
adapter->wol = adapter->eeprom_wol;
+ device_set_wakeup_enable(&adapter->pdev->dev, adapter->wol);
/* print bus type/speed/width info */
DPRINTK(PROBE, INFO, "(PCI%s:%s:%s) ",
/* print bus type/speed/width info */
DPRINTK(PROBE, INFO, "(PCI%s:%s:%s) ",