/* Slave interface type. */
enum v4l2_if_type {
+ /*
+ * Parallel 8-, 10- or 12-bit interface, used by for example
+ * on certain image sensors.
+ */
+ V4L2_IF_TYPE_BT656,
+};
+
+enum v4l2_if_type_bt656_mode {
+ /*
+ * Modes without Bt synchronisation codes. Separate
+ * synchronisation signal lines are used.
+ */
+ V4L2_IF_TYPE_BT656_MODE_NOBT_8BIT,
+ V4L2_IF_TYPE_BT656_MODE_NOBT_10BIT,
+ V4L2_IF_TYPE_BT656_MODE_NOBT_12BIT,
+ /*
+ * Use Bt synchronisation codes. The vertical and horizontal
+ * synchronisation is done based on synchronisation codes.
+ */
+ V4L2_IF_TYPE_BT656_MODE_BT_8BIT,
+ V4L2_IF_TYPE_BT656_MODE_BT_10BIT,
+};
+
+struct v4l2_if_type_bt656 {
+ /*
+ * 0: Frame begins when vsync is high.
+ * 1: Frame begins when vsync changes from low to high.
+ */
+ unsigned frame_start_on_rising_vs:1;
+ /* Use Bt synchronisation codes for sync correction. */
+ unsigned bt_sync_correct:1;
+ /* Swap every two adjacent image data elements. */
+ unsigned swap:1;
+ /* Inverted latch clock polarity from slave. */
+ unsigned latch_clk_inv:1;
+ /* Hs polarity. 0 is active high, 1 active low. */
+ unsigned nobt_hs_inv:1;
+ /* Vs polarity. 0 is active high, 1 active low. */
+ unsigned nobt_vs_inv:1;
+ enum v4l2_if_type_bt656_mode mode;
+ /* Minimum accepted bus clock for slave (in Hz). */
+ u32 clock_min;
+ /* Maximum accepted bus clock for slave. */
+ u32 clock_max;
+ /*
+ * Current wish of the slave. May only change in response to
+ * ioctls that affect image capture.
+ */
+ u32 clock_curr;
};
struct v4l2_ifparm {
enum v4l2_if_type if_type;
union {
+ struct v4l2_if_type_bt656 bt656;
} u;
};