serial: sh-sci: earlyprintk zero uartclk fix

This establishes a sensible max baud rate for the earlyprintk cases where
the port's uartclk has not yet been determined.

Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

diff --git a/drivers/serial/sh-sci.c b/drivers/serial/sh-sci.c
index 68c7f6cfd728d479f24a63c74f3231d787f81c73..a88699051136cf694a3d8df4aabac7619c0e93ce 100644 (file)
--- a/drivers/serial/sh-sci.c
+++ b/drivers/serial/sh-sci.c
@@ -897,11 +897,21 @@ static void sci_shutdown(struct uart_port *port)
 static void sci_set_termios(struct uart_port *port, struct ktermios *termios,
                            struct ktermios *old)
 {
-       unsigned int status, baud, smr_val;
+       unsigned int status, baud, smr_val, max_baud;
        int t = -1;
 
-       baud = uart_get_baud_rate(port, termios, old, 0, port->uartclk/16);
-       if (likely(baud))
+       /*
+        * earlyprintk comes here early on with port->uartclk set to zero.
+        * the clock framework is not up and running at this point so here
+        * we assume that 115200 is the maximum baud rate. please note that
+        * the baud rate is not programmed during earlyprintk - it is assumed
+        * that the previous boot loader has enabled required clocks and
+        * setup the baud rate generator hardware for us already.
+        */
+       max_baud = port->uartclk ? port->uartclk / 16 : 115200;
+
+       baud = uart_get_baud_rate(port, termios, old, 0, max_baud);
+       if (likely(baud && port->uartclk))
                t = SCBRR_VALUE(baud, port->uartclk);
 
        do {