linux-user: Adjust initial brk when interpreter is close to executable

While we attempt to load a ET_DYN executable far away from
TASK_UNMAPPED_BASE, we are not completely in control of the
address space layout.  If the interpreter lands close to
the executable, leaving insufficient heap space, move brk.

Tested-by: Helge Deller <deller@gmx.de>
Signed-off-by: Helge Deller <deller@gmx.de>
[rth: Re-order after ELF_ET_DYN_BASE patch so that we do not
 "temporarily break" tsan, and also to minimize the changes required.
 Remove image_info.reserve_brk as unused.]
Reviewed-by: Akihiko Odaki <akihiko.odaki@daynix.com>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>

diff --git a/linux-user/elfload.c b/linux-user/elfload.c
index d1b278d7999521d1cadaf2b9985d4f89588b5058..3553a3eaef0c4a314460e013fd495da81a95f837 100644 (file)
--- a/linux-user/elfload.c
+++ b/linux-user/elfload.c
@@ -3110,27 +3110,6 @@ static void load_elf_image(const char *image_name, int image_fd,
     load_addr = loaddr;
 
     if (pinterp_name != NULL) {
-        /*
-         * This is the main executable.
-         *
-         * Reserve extra space for brk.
-         * We hold on to this space while placing the interpreter
-         * and the stack, lest they be placed immediately after
-         * the data segment and block allocation from the brk.
-         *
-         * 16MB is chosen as "large enough" without being so large as
-         * to allow the result to not fit with a 32-bit guest on a
-         * 32-bit host. However some 64 bit guests (e.g. s390x)
-         * attempt to place their heap further ahead and currently
-         * nothing stops them smashing into QEMUs address space.
-         */
-#if TARGET_LONG_BITS == 64
-        info->reserve_brk = 32 * MiB;
-#else
-        info->reserve_brk = 16 * MiB;
-#endif
-        hiaddr += info->reserve_brk;
-
         if (ehdr->e_type == ET_EXEC) {
             /*
              * Make sure that the low address does not conflict with
@@ -3221,7 +3200,8 @@ static void load_elf_image(const char *image_name, int image_fd,
     info->end_code = 0;
     info->start_data = -1;
     info->end_data = 0;
-    info->brk = 0;
+    /* Usual start for brk is after all sections of the main executable. */
+    info->brk = TARGET_PAGE_ALIGN(hiaddr);
     info->elf_flags = ehdr->e_flags;
 
     prot_exec = PROT_EXEC;
@@ -3315,9 +3295,6 @@ static void load_elf_image(const char *image_name, int image_fd,
                     info->end_data = vaddr_ef;
                 }
             }
-            if (vaddr_em > info->brk) {
-                info->brk = vaddr_em;
-            }
 #ifdef TARGET_MIPS
         } else if (eppnt->p_type == PT_MIPS_ABIFLAGS) {
             Mips_elf_abiflags_v0 abiflags;
@@ -3646,6 +3623,19 @@ int load_elf_binary(struct linux_binprm *bprm, struct image_info *info)
     if (elf_interpreter) {
         load_elf_interp(elf_interpreter, &interp_info, bprm->buf);
 
+        /*
+         * While unusual because of ELF_ET_DYN_BASE, if we are unlucky
+         * with the mappings the interpreter can be loaded above but
+         * near the main executable, which can leave very little room
+         * for the heap.
+         * If the current brk has less than 16MB, use the end of the
+         * interpreter.
+         */
+        if (interp_info.brk > info->brk &&
+            interp_info.load_bias - info->brk < 16 * MiB)  {
+            info->brk = interp_info.brk;
+        }
+
         /* If the program interpreter is one of these two, then assume
            an iBCS2 image.  Otherwise assume a native linux image.  */
 
@@ -3699,17 +3689,6 @@ int load_elf_binary(struct linux_binprm *bprm, struct image_info *info)
     bprm->core_dump = &elf_core_dump;
 #endif
 
-    /*
-     * If we reserved extra space for brk, release it now.
-     * The implementation of do_brk in syscalls.c expects to be able
-     * to mmap pages in this space.
-     */
-    if (info->reserve_brk) {
-        abi_ulong start_brk = TARGET_PAGE_ALIGN(info->brk);
-        abi_ulong end_brk = TARGET_PAGE_ALIGN(info->brk + info->reserve_brk);
-        target_munmap(start_brk, end_brk - start_brk);
-    }
-
     return 0;
 }
 

diff --git a/linux-user/qemu.h b/linux-user/qemu.h
index 2046a23037f08b91cfcbeb0754efa51f811ecc57..4f8b55e2fb0a1744a18248328af8b87694391328 100644 (file)
--- a/linux-user/qemu.h
+++ b/linux-user/qemu.h
@@ -30,7 +30,6 @@ struct image_info {
         abi_ulong       start_data;
         abi_ulong       end_data;
         abi_ulong       brk;
-        abi_ulong       reserve_brk;
         abi_ulong       start_mmap;
         abi_ulong       start_stack;
         abi_ulong       stack_limit;