Some of Broadcom's PHYs run by default in slave mode with Automatic
Slave/Master configuration disabled. It stops them from working properly
with some devices.
So far it has been verified for BCM54210E and BCM50212E which don't
work well with Intel's I217-LM and I218-LM:
http://ark.intel.com/products/60019/Intel-Ethernet-Connection-I217-LM
http://ark.intel.com/products/71307/Intel-Ethernet-Connection-I218-LM
I was told there is massive ping loss.
This commit adds support for a new flag which can be set by an ethernet
driver to fixup PHY setup.
Signed-off-by: Rafał Miłecki <rafal@milecki.pl>
Signed-off-by: David S. Miller <davem@davemloft.net>
val &= ~BCM54810_SHD_CLK_CTL_GTXCLK_EN;
bcm_phy_write_shadow(phydev, BCM54810_SHD_CLK_CTL, val);
+ if (phydev->dev_flags & PHY_BRCM_EN_MASTER_MODE) {
+ val = phy_read(phydev, MII_CTRL1000);
+ val |= CTL1000_AS_MASTER | CTL1000_ENABLE_MASTER;
+ phy_write(phydev, MII_CTRL1000, val);
+ }
+
return 0;
}
#define PHY_BRCM_EXT_IBND_TX_ENABLE 0x00002000
#define PHY_BRCM_CLEAR_RGMII_MODE 0x00004000
#define PHY_BRCM_DIS_TXCRXC_NOENRGY 0x00008000
+#define PHY_BRCM_EN_MASTER_MODE 0x00010000
/* Broadcom BCM7xxx specific workarounds */
#define PHY_BRCM_7XXX_REV(x) (((x) >> 8) & 0xff)