iMX6SX IEEE 1588 module has one hw issue in capturing the ATVR register.
The current SW flow is:
ENET0->ATCR |= ENET_ATCR_CAPTURE_MASK;
ts_counter_ns = ENET0->ATVR;
The ATVR value is not expected value that cause LinuxPTP stack cannot be convergent.
ENET Block Guide/ Chapter for the iMX6SX (PELE) address the issue:
After set ENET_ATCR[Capture], there need some time cycles before the counter
value is capture in the register clock domain. The wait-time-cycles is at least
6 clock cycles of the slower clock between the register clock and the 1588 clock.
So need something like:
ENET0->ATCR |= ENET_ATCR_CAPTURE_MASK;
wait();
ts_counter_ns = ENET0->ATVR;
For iMX6SX, the 1588 ts_clk is fixed to 25Mhz, register clock is 66Mhz, so the
wait-time-cycles must be greater than 240ns (40ns * 6). The patch add 1us delay
before cpu read ATVR register.
Changes V2:
Modify the commit/comments log to describe the issue clearly.
Signed-off-by: Fugang Duan <B38611@freescale.com>
Acked-by: Richard Cochran <richardcochran@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
#define FEC_VLAN_TAG_LEN 0x04
#define FEC_ETHTYPE_LEN 0x02
+/* Controller is ENET-MAC */
+#define FEC_QUIRK_ENET_MAC (1 << 0)
+/* Controller needs driver to swap frame */
+#define FEC_QUIRK_SWAP_FRAME (1 << 1)
+/* Controller uses gasket */
+#define FEC_QUIRK_USE_GASKET (1 << 2)
+/* Controller has GBIT support */
+#define FEC_QUIRK_HAS_GBIT (1 << 3)
+/* Controller has extend desc buffer */
+#define FEC_QUIRK_HAS_BUFDESC_EX (1 << 4)
+/* Controller has hardware checksum support */
+#define FEC_QUIRK_HAS_CSUM (1 << 5)
+/* Controller has hardware vlan support */
+#define FEC_QUIRK_HAS_VLAN (1 << 6)
+/* ENET IP errata ERR006358
+ *
+ * If the ready bit in the transmit buffer descriptor (TxBD[R]) is previously
+ * detected as not set during a prior frame transmission, then the
+ * ENET_TDAR[TDAR] bit is cleared at a later time, even if additional TxBDs
+ * were added to the ring and the ENET_TDAR[TDAR] bit is set. This results in
+ * frames not being transmitted until there is a 0-to-1 transition on
+ * ENET_TDAR[TDAR].
+ */
+#define FEC_QUIRK_ERR006358 (1 << 7)
+/* ENET IP hw AVB
+ *
+ * i.MX6SX ENET IP add Audio Video Bridging (AVB) feature support.
+ * - Two class indicators on receive with configurable priority
+ * - Two class indicators and line speed timer on transmit allowing
+ * implementation class credit based shapers externally
+ * - Additional DMA registers provisioned to allow managing up to 3
+ * independent rings
+ */
+#define FEC_QUIRK_HAS_AVB (1 << 8)
+/* There is a TDAR race condition for mutliQ when the software sets TDAR
+ * and the UDMA clears TDAR simultaneously or in a small window (2-4 cycles).
+ * This will cause the udma_tx and udma_tx_arbiter state machines to hang.
+ * The issue exist at i.MX6SX enet IP.
+ */
+#define FEC_QUIRK_ERR007885 (1 << 9)
+/* ENET Block Guide/ Chapter for the iMX6SX (PELE) address one issue:
+ * After set ENET_ATCR[Capture], there need some time cycles before the counter
+ * value is capture in the register clock domain.
+ * The wait-time-cycles is at least 6 clock cycles of the slower clock between
+ * the register clock and the 1588 clock. The 1588 ts_clk is fixed to 25Mhz,
+ * register clock is 66Mhz, so the wait-time-cycles must be greater than 240ns
+ * (40ns * 6).
+ */
+#define FEC_QUIRK_BUG_CAPTURE (1 << 10)
+
struct fec_enet_priv_tx_q {
int index;
unsigned char *tx_bounce[TX_RING_SIZE];
#define FEC_ENET_RAFL_V 0x8
#define FEC_ENET_OPD_V 0xFFF0
-/* Controller is ENET-MAC */
-#define FEC_QUIRK_ENET_MAC (1 << 0)
-/* Controller needs driver to swap frame */
-#define FEC_QUIRK_SWAP_FRAME (1 << 1)
-/* Controller uses gasket */
-#define FEC_QUIRK_USE_GASKET (1 << 2)
-/* Controller has GBIT support */
-#define FEC_QUIRK_HAS_GBIT (1 << 3)
-/* Controller has extend desc buffer */
-#define FEC_QUIRK_HAS_BUFDESC_EX (1 << 4)
-/* Controller has hardware checksum support */
-#define FEC_QUIRK_HAS_CSUM (1 << 5)
-/* Controller has hardware vlan support */
-#define FEC_QUIRK_HAS_VLAN (1 << 6)
-/* ENET IP errata ERR006358
- *
- * If the ready bit in the transmit buffer descriptor (TxBD[R]) is previously
- * detected as not set during a prior frame transmission, then the
- * ENET_TDAR[TDAR] bit is cleared at a later time, even if additional TxBDs
- * were added to the ring and the ENET_TDAR[TDAR] bit is set. This results in
- * frames not being transmitted until there is a 0-to-1 transition on
- * ENET_TDAR[TDAR].
- */
-#define FEC_QUIRK_ERR006358 (1 << 7)
-/* ENET IP hw AVB
- *
- * i.MX6SX ENET IP add Audio Video Bridging (AVB) feature support.
- * - Two class indicators on receive with configurable priority
- * - Two class indicators and line speed timer on transmit allowing
- * implementation class credit based shapers externally
- * - Additional DMA registers provisioned to allow managing up to 3
- * independent rings
- */
-#define FEC_QUIRK_HAS_AVB (1 << 8)
-/* There is a TDAR race condition for mutliQ when the software sets TDAR
- * and the UDMA clears TDAR simultaneously or in a small window (2-4 cycles).
- * This will cause the udma_tx and udma_tx_arbiter state machines to hang.
- * The issue exist at i.MX6SX enet IP.
- */
-#define FEC_QUIRK_ERR007885 (1 << 9)
-
static struct platform_device_id fec_devtype[] = {
{
/* keep it for coldfire */
.driver_data = FEC_QUIRK_ENET_MAC | FEC_QUIRK_HAS_GBIT |
FEC_QUIRK_HAS_BUFDESC_EX | FEC_QUIRK_HAS_CSUM |
FEC_QUIRK_HAS_VLAN | FEC_QUIRK_HAS_AVB |
- FEC_QUIRK_ERR007885,
+ FEC_QUIRK_ERR007885 | FEC_QUIRK_BUG_CAPTURE,
}, {
/* sentinel */
}
{
struct fec_enet_private *fep =
container_of(cc, struct fec_enet_private, cc);
+ const struct platform_device_id *id_entry =
+ platform_get_device_id(fep->pdev);
u32 tempval;
tempval = readl(fep->hwp + FEC_ATIME_CTRL);
tempval |= FEC_T_CTRL_CAPTURE;
writel(tempval, fep->hwp + FEC_ATIME_CTRL);
+ if (id_entry->driver_data & FEC_QUIRK_BUG_CAPTURE)
+ udelay(1);
+
return readl(fep->hwp + FEC_ATIME);
}
projects / mirror_ubuntu-eoan-kernel.git / commitdiff