Reading e1000e_check_for_copper_link() shows that get_link_status is set to
false after link has been detected. Therefore, it stays TRUE until then.
Signed-off-by: Benjamin Poirier <bpoirier@suse.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
/* get_link_status is set on LSC (link status) interrupt or
* Rx sequence error interrupt. get_link_status will stay
- * false until the check_for_link establishes link
+ * true until the check_for_link establishes link
* for copper adapters ONLY
*/
switch (hw->phy.media_type) {
break;
case e1000_media_type_internal_serdes:
ret_val = hw->mac.ops.check_for_link(hw);
- link_active = adapter->hw.mac.serdes_has_link;
+ link_active = hw->mac.serdes_has_link;
break;
default:
case e1000_media_type_unknown: