ew32(CTRL_EXT, reg);
}
+ if (hw->mac.type == e1000_82571) {
+ reg = er32(PBA_ECC);
+ reg |= E1000_PBA_ECC_CORR_EN;
+ ew32(PBA_ECC, reg);
+ }
+
/* PCI-Ex Control Register */
if (hw->mac.type == e1000_82574) {
reg = er32(GCR);
#define E1000_ICR_TXQ1 0x00800000 /* Tx Queue 1 Interrupt */
#define E1000_ICR_OTHER 0x01000000 /* Other Interrupts */
+/* PBA ECC Register */
+#define E1000_PBA_ECC_COUNTER_MASK 0xFFF00000 /* ECC counter mask */
+#define E1000_PBA_ECC_COUNTER_SHIFT 20 /* ECC counter shift value */
+#define E1000_PBA_ECC_CORR_EN 0x00000001 /* ECC correction enable */
+#define E1000_PBA_ECC_STAT_CLR 0x00000002 /* Clear ECC error counter */
+#define E1000_PBA_ECC_INT_EN 0x00000004 /* Enable ICR bit 5 for ECC */
+
/*
* This defines the bits that are set in the Interrupt Mask
* Set/Read Register. Each bit is documented below:
E1000_EEMNGCTL = 0x01010, /* MNG EEprom Control */
E1000_EEWR = 0x0102C, /* EEPROM Write Register - RW */
E1000_FLOP = 0x0103C, /* FLASH Opcode Register */
+ E1000_PBA_ECC = 0x01100, /* PBA ECC Register */
E1000_ERT = 0x02008, /* Early Rx Threshold - RW */
E1000_FCRTL = 0x02160, /* Flow Control Receive Threshold Low - RW */
E1000_FCRTH = 0x02168, /* Flow Control Receive Threshold High - RW */