Some of the comments in the ab8500 drivers reflect the behaviour
of the original device. As this driver now supports newer devices
then these comments are now redundant. Also some IRQ comments are
incorrect.
Signed-off-by: Marcus Cooper <marcus.xm.cooper@stericsson.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
Reviewed-by: Rabin VINCENT <rabin.vincent@stericsson.com>
Tested-by: Rabin VINCENT <rabin.vincent@stericsson.com>
if (di->bm->adc_therm == ABx500_ADC_THERM_BATCTRL) {
/*
* If the battery has internal NTC, we use the current
- * source to calculate the resistance, 7uA or 20uA
+ * source to calculate the resistance.
*/
rbs = (v_batctrl * 1000
- di->bm->gnd_lift_resistance * inst_curr)
/*
* We only have to change current source if the
- * detected type is Type 1, else we use the 7uA source
+ * detected type is Type 1.
*/
if (di->bm->adc_therm == ABx500_ADC_THERM_BATCTRL &&
di->bm->batt_id == 1) {
}
/**
- * ab8500_fg_cc_data_end_handler() - isr to get battery avg current.
+ * ab8500_fg_cc_data_end_handler() - end of data conversion isr.
* @irq: interrupt number
* @_di: pointer to the ab8500_fg structure
*
}
/**
- * ab8500_fg_cc_convend_handler() - isr to get battery avg current.
+ * ab8500_fg_cc_int_calib_handler () - end of calibration isr.
* @irq: interrupt number
* @_di: pointer to the ab8500_fg structure
*