--- /dev/null
+/*
+ * ALPHAPROJECT AP-SH4AD-0A Support.
+ *
+ * Copyright (C) 2010 ALPHAPROJECT Co.,Ltd.
+ * Copyright (C) 2010 Matt Fleming
+ * Copyright (C) 2010 Paul Mundt
+ *
+ * This file is subject to the terms and conditions of the GNU General Public
+ * License. See the file "COPYING" in the main directory of this archive
+ * for more details.
+ */
+#include <linux/init.h>
+#include <linux/platform_device.h>
+#include <linux/io.h>
+#include <linux/smsc911x.h>
+#include <linux/irq.h>
+#include <linux/clk.h>
+#include <asm/machvec.h>
+#include <asm/sizes.h>
+
+static struct resource smsc911x_resources[] = {
+ [0] = {
+ .name = "smsc911x-memory",
+ .start = 0xA4000000,
+ .end = 0xA4000000 + SZ_256 - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .name = "smsc911x-irq",
+ .start = evt2irq(0x200),
+ .end = evt2irq(0x200),
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static struct smsc911x_platform_config smsc911x_config = {
+ .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
+ .irq_type = SMSC911X_IRQ_TYPE_OPEN_DRAIN,
+ .flags = SMSC911X_USE_16BIT,
+ .phy_interface = PHY_INTERFACE_MODE_MII,
+};
+
+static struct platform_device smsc911x_device = {
+ .name = "smsc911x",
+ .id = -1,
+ .num_resources = ARRAY_SIZE(smsc911x_resources),
+ .resource = smsc911x_resources,
+ .dev = {
+ .platform_data = &smsc911x_config,
+ },
+};
+
+static struct platform_device *apsh4ad0a_devices[] __initdata = {
+ &smsc911x_device,
+};
+
+static int __init apsh4ad0a_devices_setup(void)
+{
+ return platform_add_devices(apsh4ad0a_devices,
+ ARRAY_SIZE(apsh4ad0a_devices));
+}
+device_initcall(apsh4ad0a_devices_setup);
+
+static int apsh4ad0a_mode_pins(void)
+{
+ int value = 0;
+
+ /* These are the factory default settings of SW1 and SW2.
+ * If you change these dip switches then you will need to
+ * adjust the values below as well.
+ */
+ value |= MODE_PIN0; /* Clock Mode 3 */
+ value |= MODE_PIN1;
+ value &= ~MODE_PIN2;
+ value &= ~MODE_PIN3;
+ value &= ~MODE_PIN4; /* 16-bit Area0 bus width */
+ value |= MODE_PIN5;
+ value |= MODE_PIN6;
+ value |= MODE_PIN7; /* Normal mode */
+ value |= MODE_PIN8; /* Little Endian */
+ value |= MODE_PIN9; /* Crystal resonator */
+ value &= ~MODE_PIN10; /* 29-bit address mode */
+ value &= ~MODE_PIN11; /* PCI-E Root port */
+ value &= ~MODE_PIN12; /* 4 lane + 1 lane */
+ value |= MODE_PIN13; /* AUD Enable */
+ value &= ~MODE_PIN14; /* Normal Operation */
+
+ return value;
+}
+
+static int apsh4ad0a_clk_init(void)
+{
+ struct clk *clk;
+ int ret;
+
+ clk = clk_get(NULL, "extal");
+ if (!clk || IS_ERR(clk))
+ return PTR_ERR(clk);
+ ret = clk_set_rate(clk, 33333000);
+ clk_put(clk);
+
+ return ret;
+}
+
+/* Initialize the board */
+static void __init apsh4ad0a_setup(char **cmdline_p)
+{
+ pr_info("Alpha Project AP-SH4AD-0A support:\n");
+}
+
+static void __init apsh4ad0a_init_irq(void)
+{
+ plat_irq_setup_pins(IRQ_MODE_IRQ3210);
+}
+
+/*
+ * The Machine Vector
+ */
+static struct sh_machine_vector mv_apsh4ad0a __initmv = {
+ .mv_name = "AP-SH4AD-0A",
+ .mv_setup = apsh4ad0a_setup,
+ .mv_mode_pins = apsh4ad0a_mode_pins,
+ .mv_clk_init = apsh4ad0a_clk_init,
+ .mv_init_irq = apsh4ad0a_init_irq,
+};
--- /dev/null
+CONFIG_EXPERIMENTAL=y
+CONFIG_SYSVIPC=y
+CONFIG_POSIX_MQUEUE=y
+CONFIG_BSD_PROCESS_ACCT=y
+CONFIG_RCU_TRACE=y
+CONFIG_IKCONFIG=y
+CONFIG_IKCONFIG_PROC=y
+CONFIG_LOG_BUF_SHIFT=14
+CONFIG_CGROUPS=y
+CONFIG_CGROUP_NS=y
+CONFIG_CGROUP_FREEZER=y
+CONFIG_CGROUP_DEVICE=y
+CONFIG_CGROUP_CPUACCT=y
+CONFIG_RESOURCE_COUNTERS=y
+CONFIG_CGROUP_MEM_RES_CTLR=y
+CONFIG_BLK_CGROUP=y
+CONFIG_NAMESPACES=y
+CONFIG_BLK_DEV_INITRD=y
+CONFIG_KALLSYMS_ALL=y
+# CONFIG_COMPAT_BRK is not set
+CONFIG_SLAB=y
+CONFIG_PROFILING=y
+CONFIG_MODULES=y
+CONFIG_MODULE_UNLOAD=y
+# CONFIG_LBDAF is not set
+# CONFIG_BLK_DEV_BSG is not set
+CONFIG_CFQ_GROUP_IOSCHED=y
+CONFIG_CPU_SUBTYPE_SH7786=y
+CONFIG_MEMORY_SIZE=0x10000000
+CONFIG_HUGETLB_PAGE_SIZE_1MB=y
+CONFIG_MEMORY_HOTPLUG=y
+CONFIG_MEMORY_HOTREMOVE=y
+CONFIG_KSM=y
+CONFIG_SH_STORE_QUEUES=y
+CONFIG_SH_APSH4AD0A=y
+CONFIG_NO_HZ=y
+CONFIG_HIGH_RES_TIMERS=y
+CONFIG_CPU_FREQ=y
+CONFIG_CPU_FREQ_GOV_POWERSAVE=m
+CONFIG_CPU_FREQ_GOV_USERSPACE=m
+CONFIG_CPU_FREQ_GOV_ONDEMAND=m
+CONFIG_CPU_FREQ_GOV_CONSERVATIVE=m
+CONFIG_SH_CPU_FREQ=y
+CONFIG_KEXEC=y
+CONFIG_SECCOMP=y
+CONFIG_PREEMPT=y
+# CONFIG_CORE_DUMP_DEFAULT_ELF_HEADERS is not set
+CONFIG_BINFMT_MISC=y
+CONFIG_PM=y
+CONFIG_PM_DEBUG=y
+CONFIG_PM_VERBOSE=y
+CONFIG_PM_RUNTIME=y
+CONFIG_CPU_IDLE=y
+CONFIG_NET=y
+CONFIG_PACKET=y
+CONFIG_UNIX=y
+CONFIG_NET_KEY=y
+CONFIG_INET=y
+# CONFIG_INET_LRO is not set
+# CONFIG_IPV6 is not set
+# CONFIG_WIRELESS is not set
+CONFIG_UEVENT_HELPER_PATH="/sbin/hotplug"
+# CONFIG_FW_LOADER is not set
+CONFIG_MTD=y
+CONFIG_MTD_CFI=y
+CONFIG_BLK_DEV_RAM=y
+CONFIG_BLK_DEV_RAM_SIZE=16384
+CONFIG_SCSI=y
+CONFIG_BLK_DEV_SD=y
+CONFIG_SCSI_MULTI_LUN=y
+# CONFIG_SCSI_LOWLEVEL is not set
+CONFIG_NETDEVICES=y
+CONFIG_MDIO_BITBANG=y
+CONFIG_NET_ETHERNET=y
+CONFIG_SMSC911X=y
+# CONFIG_NETDEV_1000 is not set
+# CONFIG_NETDEV_10000 is not set
+# CONFIG_WLAN is not set
+CONFIG_INPUT_EVDEV=y
+# CONFIG_INPUT_KEYBOARD is not set
+# CONFIG_INPUT_MOUSE is not set
+# CONFIG_SERIO is not set
+CONFIG_SERIAL_SH_SCI=y
+CONFIG_SERIAL_SH_SCI_NR_UARTS=6
+CONFIG_SERIAL_SH_SCI_CONSOLE=y
+# CONFIG_LEGACY_PTYS is not set
+# CONFIG_HW_RANDOM is not set
+# CONFIG_HWMON is not set
+CONFIG_VIDEO_OUTPUT_CONTROL=y
+CONFIG_FB=y
+CONFIG_FB_SH7785FB=y
+CONFIG_FRAMEBUFFER_CONSOLE=y
+CONFIG_FONTS=y
+CONFIG_FONT_8x8=y
+CONFIG_FONT_8x16=y
+CONFIG_LOGO=y
+CONFIG_USB=y
+CONFIG_USB_DEBUG=y
+CONFIG_USB_MON=y
+CONFIG_USB_OHCI_HCD=y
+CONFIG_USB_STORAGE=y
+CONFIG_EXT2_FS=y
+CONFIG_EXT3_FS=y
+# CONFIG_EXT3_DEFAULTS_TO_ORDERED is not set
+CONFIG_MSDOS_FS=y
+CONFIG_VFAT_FS=y
+CONFIG_NTFS_FS=y
+CONFIG_NTFS_RW=y
+CONFIG_PROC_KCORE=y
+CONFIG_TMPFS=y
+CONFIG_HUGETLBFS=y
+CONFIG_JFFS2_FS=y
+CONFIG_CRAMFS=y
+CONFIG_NFS_FS=y
+CONFIG_NFS_V3=y
+CONFIG_NFS_V4=y
+CONFIG_CIFS=y
+CONFIG_NLS_DEFAULT="utf8"
+CONFIG_NLS_CODEPAGE_437=y
+CONFIG_NLS_CODEPAGE_932=y
+CONFIG_NLS_ASCII=y
+CONFIG_NLS_ISO8859_1=y
+CONFIG_NLS_UTF8=y
+# CONFIG_ENABLE_MUST_CHECK is not set
+CONFIG_MAGIC_SYSRQ=y
+CONFIG_DEBUG_KERNEL=y
+CONFIG_DEBUG_SHIRQ=y
+CONFIG_DETECT_HUNG_TASK=y
+CONFIG_DEBUG_INFO=y
+CONFIG_DEBUG_VM=y
+# CONFIG_RCU_CPU_STALL_DETECTOR is not set
+CONFIG_DWARF_UNWINDER=y
+# CONFIG_CRYPTO_ANSI_CPRNG is not set
projects / mirror_ubuntu-kernels.git / commitdiff