Convert the bindings for McASP controllers for TI SoCs from txt
to YAML schema.
Adds additional properties 'clocks', 'clock-names', 'power-domains',
'#sound-dai-cells' and 'port' which were missing from the txt file.
Removes properties 'sram-size-playback' and 'sram-size-capture'
since they are not used.
Adds 'dmas' and 'dma-names' in the example which were missing from
the txt file.
Changes 'interrupts' and 'interrupt-names' from optional to
required properties.
Changes 'op-modes', 'serial-dir' to optional properties as they are
not needed if the McASP is used only as GPIO.
Changes 'tdm-slots' to required property only for I2S operation mode.
Adds the yaml file in the 'MAINTAINERS' under the heading 'TEXAS
INSTRUMENTS ASoC DRIVERS'
Signed-off-by: Jayesh Choudhary <j-choudhary@ti.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Acked-by: Peter Ujfalusi <peter.ujfalusi@gmail.com>
Link: https://lore.kernel.org/r/20220209063008.2928-1-j-choudhary@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>
+++ /dev/null
-Texas Instruments McASP controller
-
-Required properties:
-- compatible :
- "ti,dm646x-mcasp-audio" : for DM646x platforms
- "ti,da830-mcasp-audio" : for both DA830 & DA850 platforms
- "ti,am33xx-mcasp-audio" : for AM33xx platforms (AM33xx, AM43xx, TI81xx)
- "ti,dra7-mcasp-audio" : for DRA7xx platforms
- "ti,omap4-mcasp-audio" : for OMAP4
-
-- reg : Should contain reg specifiers for the entries in the reg-names property.
-- reg-names : Should contain:
- * "mpu" for the main registers (required). For compatibility with
- existing software, it is recommended this is the first entry.
- * "dat" for separate data port register access (optional).
-- op-mode : I2S/DIT ops mode. 0 for I2S mode. 1 for DIT mode used for S/PDIF,
- IEC60958-1, and AES-3 formats.
-- tdm-slots : Slots for TDM operation. Indicates number of channels transmitted
- or received over one serializer.
-- serial-dir : A list of serializer configuration. Each entry is a number
- indication for serializer pin direction.
- (0 - INACTIVE, 1 - TX, 2 - RX)
-- dmas: two element list of DMA controller phandles and DMA request line
- ordered pairs.
-- dma-names: identifier string for each DMA request line in the dmas property.
- These strings correspond 1:1 with the ordered pairs in dmas. The dma
- identifiers must be "rx" and "tx".
-
-Optional properties:
-
-- ti,hwmods : Must be "mcasp<n>", n is controller instance starting 0
-- tx-num-evt : FIFO levels.
-- rx-num-evt : FIFO levels.
-- dismod : Specify the drive on TX pin during inactive slots
- 0 : 3-state
- 2 : logic low
- 3 : logic high
- Defaults to 'logic low' when the property is not present
-- sram-size-playback : size of sram to be allocated during playback
-- sram-size-capture : size of sram to be allocated during capture
-- interrupts : Interrupt numbers for McASP
-- interrupt-names : Known interrupt names are "tx" and "rx"
-- pinctrl-0: Should specify pin control group used for this controller.
-- pinctrl-names: Should contain only one value - "default", for more details
- please refer to pinctrl-bindings.txt
-- fck_parent : Should contain a valid clock name which will be used as parent
- for the McASP fck
-- auxclk-fs-ratio: When McASP is bus master indicates the ratio between AUCLK
- and FS rate if applicable:
- AUCLK rate = auxclk-fs-ratio * FS rate
-
-Optional GPIO support:
-If any McASP pin need to be used as GPIO then the McASP node must have:
-...
- gpio-controller
- #gpio-cells = <2>;
-...
-
-When requesting a GPIO, the first parameter is the PIN index in McASP_P*
-registers.
-For example to request the AXR2 pin of mcasp8:
-function-gpios = <&mcasp8 2 0>;
-
-Or to request the ACLKR pin of mcasp8:
-function-gpios = <&mcasp8 29 0>;
-
-For generic gpio information, please refer to bindings/gpio/gpio.txt
-
-Example:
-
-mcasp0: mcasp0@1d00000 {
- compatible = "ti,da830-mcasp-audio";
- reg = <0x100000 0x3000>;
- reg-names "mpu";
- interrupts = <82>, <83>;
- interrupt-names = "tx", "rx";
- op-mode = <0>; /* MCASP_IIS_MODE */
- tdm-slots = <2>;
- serial-dir = <
- 0 0 0 0 /* 0: INACTIVE, 1: TX, 2: RX */
- 0 0 0 0
- 0 0 0 1
- 2 0 0 0 >;
- tx-num-evt = <1>;
- rx-num-evt = <1>;
-};
--- /dev/null
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/sound/davinci-mcasp-audio.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: McASP Controller for TI SoCs
+
+maintainers:
+ - Jayesh Choudhary <j-choudhary@ti.com>
+
+properties:
+ compatible:
+ enum:
+ - ti,dm646x-mcasp-audio
+ - ti,da830-mcasp-audio
+ - ti,am33xx-mcasp-audio
+ - ti,dra7-mcasp-audio
+ - ti,omap4-mcasp-audio
+
+ reg:
+ minItems: 1
+ items:
+ - description: CFG registers
+ - description: data registers
+
+ reg-names:
+ minItems: 1
+ items:
+ - const: mpu
+ - const: dat
+
+ op-mode:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description: 0 - I2S or 1 - DIT operation mode
+ enum:
+ - 0
+ - 1
+
+ tdm-slots:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ number of channels over one serializer
+ the property is ignored in DIT mode
+ minimum: 2
+ maximum: 32
+
+ serial-dir:
+ description:
+ A list of serializer configuration
+ Entry is indication for serializer pin direction
+ 0 - Inactive, 1 - TX, 2 - RX
+ All AXR pins should be present in the array even if inactive
+ $ref: /schemas/types.yaml#/definitions/uint32-array
+ minItems: 1
+ maxItems: 25
+ items:
+ minimum: 0
+ maximum: 2
+
+ dmas:
+ minItems: 1
+ items:
+ - description: transmission DMA channel
+ - description: reception DMA channel
+
+ dma-names:
+ minItems: 1
+ items:
+ - const: tx
+ - const: rx
+
+ ti,hwmods:
+ $ref: /schemas/types.yaml#/definitions/string
+ description: Name of hwmod associated with McASP
+ maxItems: 1
+ deprecated: true
+
+ tx-num-evt:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ configures WFIFO threshold
+ 0 disables the FIFO use
+ if property is missing, then also FIFO use is disabled
+
+ rx-num-evt:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ configures RFIFO threshold
+ 0 disables the FIFO use
+ if property is missing, then also FIFO use is disabled
+
+ dismod:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ specify the drive on TX pin during inactive time slots
+ 0 - 3-state, 2 - logic low, 3 - logic high
+ enum:
+ - 0
+ - 2
+ - 3
+ default: 2
+
+ interrupts:
+ anyOf:
+ - minItems: 1
+ items:
+ - description: TX interrupt
+ - description: RX interrupt
+ - items:
+ - description: common/combined interrupt
+
+ interrupt-names:
+ oneOf:
+ - minItems: 1
+ items:
+ - const: tx
+ - const: rx
+ - const: common
+
+ fck_parent:
+ $ref: /schemas/types.yaml#/definitions/string
+ description: parent clock name for McASP fck
+ maxItems: 1
+
+ auxclk-fs-ratio:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description: ratio of AUCLK and FS rate if applicable
+
+ gpio-controller: true
+
+ "#gpio-cells":
+ const: 2
+
+ clocks:
+ minItems: 1
+ items:
+ - description: functional clock
+ - description: module specific optional ahclkx clock
+ - description: module specific optional ahclkr clock
+
+ clock-names:
+ minItems: 1
+ items:
+ - const: fck
+ - const: ahclkx
+ - const: ahclkr
+
+ power-domains:
+ description: phandle to the corresponding power-domain
+ maxItems: 1
+
+ "#sound-dai-cells":
+ const: 0
+
+ port:
+ description: connection for when McASP is used via graph card
+ type: object
+
+required:
+ - compatible
+ - reg
+ - reg-names
+ - dmas
+ - dma-names
+ - interrupts
+ - interrupt-names
+
+allOf:
+ - if:
+ properties:
+ opmode:
+ enum:
+ - 0
+
+ then:
+ required:
+ - tdm-slots
+
+additionalProperties: false
+
+examples:
+ - |
+ mcasp0: mcasp0@1d00000 {
+ compatible = "ti,da830-mcasp-audio";
+ reg = <0x100000 0x3000>;
+ reg-names = "mpu";
+ interrupts = <82>, <83>;
+ interrupt-names = "tx", "rx";
+ op-mode = <0>; /* MCASP_IIS_MODE */
+ tdm-slots = <2>;
+ dmas = <&main_udmap 0xc400>, <&main_udmap 0x4400>;
+ dma-names = "tx", "rx";
+ serial-dir = <
+ 0 0 0 0 /* 0: INACTIVE, 1: TX, 2: RX */
+ 0 0 0 0
+ 0 0 0 1
+ 2 0 0 0 >;
+ tx-num-evt = <1>;
+ rx-num-evt = <1>;
+ };
M: Peter Ujfalusi <peter.ujfalusi@gmail.com>
L: alsa-devel@alsa-project.org (moderated for non-subscribers)
S: Maintained
+F: Documentation/devicetree/bindings/sound/davinci-mcasp-audio.yaml
F: sound/soc/ti/
TEXAS INSTRUMENTS' DAC7612 DAC DRIVER
projects / mirror_ubuntu-kernels.git / commitdiff