ath5k: fix setup for CAB queue

The beacon sent gating doesn't seem to work with any combination
of flags.  Thus, buffered frames tend to stay buffered forever,
using up tx descriptors.

Instead, use the DBA gating and hold transmission of the buffered
frames until 80% of the beacon interval has elapsed using the ready
time.  This fixes the following error in AP mode:

   ath5k phy0: no further txbuf available, dropping packet

Add a comment to acknowledge that this isn't the best solution.

Signed-off-by: Bob Copeland <me@bobcopeland.com>
Acked-by: Nick Kossifidis <mickflemm@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

diff --git a/drivers/net/wireless/ath/ath5k/ath5k.h b/drivers/net/wireless/ath/ath5k/ath5k.h
index 66bcb506a1123e7f25e82ef7fa7d46a1b48f8aed..ad4d446f02646d6d1714c17b3c28e8620a19938b 100644 (file)
--- a/drivers/net/wireless/ath/ath5k/ath5k.h
+++ b/drivers/net/wireless/ath/ath5k/ath5k.h
@@ -535,7 +535,7 @@ struct ath5k_txq_info {
        u32     tqi_cbr_period; /* Constant bit rate period */
        u32     tqi_cbr_overflow_limit;
        u32     tqi_burst_time;
-       u32     tqi_ready_time; /* Not used */
+       u32     tqi_ready_time; /* Time queue waits after an event */
 };
 
 /*

diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index b5015376d4bac9cfda9f05fc55e15d820a17ffb4..535a6afb94e3564d50c12e003bdca0905cbe5673 100644 (file)
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -1516,7 +1516,8 @@ ath5k_beaconq_config(struct ath5k_softc *sc)
 
        ret = ath5k_hw_get_tx_queueprops(ah, sc->bhalq, &qi);
        if (ret)
-               return ret;
+               goto err;
+
        if (sc->opmode == NL80211_IFTYPE_AP ||
                sc->opmode == NL80211_IFTYPE_MESH_POINT) {
                /*
@@ -1543,10 +1544,25 @@ ath5k_beaconq_config(struct ath5k_softc *sc)
        if (ret) {
                ATH5K_ERR(sc, "%s: unable to update parameters for beacon "
                        "hardware queue!\n", __func__);
-               return ret;
+               goto err;
        }
+       ret = ath5k_hw_reset_tx_queue(ah, sc->bhalq); /* push to h/w */
+       if (ret)
+               goto err;
 
-       return ath5k_hw_reset_tx_queue(ah, sc->bhalq); /* push to h/w */;
+       /* reconfigure cabq with ready time to 80% of beacon_interval */
+       ret = ath5k_hw_get_tx_queueprops(ah, AR5K_TX_QUEUE_ID_CAB, &qi);
+       if (ret)
+               goto err;
+
+       qi.tqi_ready_time = (sc->bintval * 80) / 100;
+       ret = ath5k_hw_set_tx_queueprops(ah, AR5K_TX_QUEUE_ID_CAB, &qi);
+       if (ret)
+               goto err;
+
+       ret = ath5k_hw_reset_tx_queue(ah, AR5K_TX_QUEUE_ID_CAB);
+err:
+       return ret;
 }
 
 static void

diff --git a/drivers/net/wireless/ath/ath5k/qcu.c b/drivers/net/wireless/ath/ath5k/qcu.c
index abe36c0d139c72f4e60dde1d006423b82185570b..9122a8556f45c3e02a6e2e215f16702458f14147 100644 (file)
--- a/drivers/net/wireless/ath/ath5k/qcu.c
+++ b/drivers/net/wireless/ath/ath5k/qcu.c
@@ -408,12 +408,13 @@ int ath5k_hw_reset_tx_queue(struct ath5k_hw *ah, unsigned int queue)
                        break;
 
                case AR5K_TX_QUEUE_CAB:
+                       /* XXX: use BCN_SENT_GT, if we can figure out how */
                        AR5K_REG_ENABLE_BITS(ah, AR5K_QUEUE_MISC(queue),
-                               AR5K_QCU_MISC_FRSHED_BCN_SENT_GT |
+                               AR5K_QCU_MISC_FRSHED_DBA_GT |
                                AR5K_QCU_MISC_CBREXP_DIS |
                                AR5K_QCU_MISC_CBREXP_BCN_DIS);
 
-                       ath5k_hw_reg_write(ah, ((AR5K_TUNE_BEACON_INTERVAL -
+                       ath5k_hw_reg_write(ah, ((tq->tqi_ready_time -
                                (AR5K_TUNE_SW_BEACON_RESP -
                                AR5K_TUNE_DMA_BEACON_RESP) -
                                AR5K_TUNE_ADDITIONAL_SWBA_BACKOFF) * 1024) |