These divide off of PLLD_PER and are used for the ethernet and wifi
PHYs source PLLs. Neither of them is currently represented by a phy
device that would grab the clock for us.
This keeps other drivers from killing the networking PHYs when they
disable their own clocks and trigger PLLD_PER's refcount going to 0.
v2: Skip marking as critical if they aren't on at boot.
Signed-off-by: Eric Anholt <eric@anholt.net>
init.name = data->name;
init.flags = data->flags | CLK_IGNORE_UNUSED;
+ /*
+ * Some GPIO clocks for ethernet/wifi PLLs are marked as
+ * critical (since some platforms use them), but if the
+ * firmware didn't have them turned on then they clearly
+ * aren't actually critical.
+ */
+ if ((cprman_read(cprman, data->ctl_reg) & CM_ENABLE) == 0)
+ init.flags &= ~CLK_IS_CRITICAL;
+
/*
* Pass the CLK_SET_RATE_PARENT flag if we are allowed to propagate
* rate changes on at least of the parents.