ARM: dts: fix RealView EB SMSC ethernet version

The ethernet version in the earlier RealView EB variants is
LAN91C111 and not LAN9118 according to ARM DUI 0303E
"RealView Emulation Baseboard User Guide" page 3-57.

Make sure that this is used for the base variant of the board.

As the DT bindings for LAN91C111 does not specify any power
supplies, these need to be deleted from the DTS file.

Fixes: 2440d29d2ae2 ("ARM: dts: realview: support all the RealView EB board variants")
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/arch/arm/boot/dts/arm-realview-eb.dtsi b/arch/arm/boot/dts/arm-realview-eb.dtsi
index 1c6a040218e3f9a77c72356f8e257d045148d7e9..e2e9599596e25be3600ff40a6b1b74d62e3bcdb0 100644 (file)
--- a/arch/arm/boot/dts/arm-realview-eb.dtsi
+++ b/arch/arm/boot/dts/arm-realview-eb.dtsi
@@ -51,14 +51,6 @@
                regulator-boot-on;
         };
 
-       veth: fixedregulator@0 {
-               compatible = "regulator-fixed";
-               regulator-name = "veth";
-               regulator-min-microvolt = <3300000>;
-               regulator-max-microvolt = <3300000>;
-               regulator-boot-on;
-       };
-
        xtal24mhz: xtal24mhz@24M {
                #clock-cells = <0>;
                compatible = "fixed-clock";
@@ -134,16 +126,15 @@
                bank-width = <4>;
        };
 
-       /* SMSC 9118 ethernet with PHY and EEPROM */
+       /* SMSC LAN91C111 ethernet with PHY and EEPROM */
        ethernet: ethernet@4e000000 {
-               compatible = "smsc,lan9118", "smsc,lan9115";
+               compatible = "smsc,lan91c111";
                reg = <0x4e000000 0x10000>;
-               phy-mode = "mii";
-               reg-io-width = <4>;
-               smsc,irq-active-high;
-               smsc,irq-push-pull;
-               vdd33a-supply = <&veth>;
-               vddvario-supply = <&veth>;
+               /*
+                * This means the adapter can be accessed with 8, 16 or
+                * 32 bit reads/writes.
+                */
+               reg-io-width = <7>;
        };
 
        usb: usb@4f000000 {