If there is no connection, driver will enter IPS state. Meanwhile, it
fails to scan channel 1 by the command 'iw dev wlan0 scan freq 2412',
because hardware channel setting lose after IPS. Thus, restore channel
setting from hw->conf.channel set by last rtl_op_config().
Signed-off-by: Tim Lee <timlee@realtek.com>
Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
&rtlmac->retry_long);
RT_CLEAR_PS_LEVEL(ppsc, RT_RF_OFF_LEVL_HALT_NIC);
+ rtlpriv->cfg->ops->switch_channel(hw);
+ rtlpriv->cfg->ops->set_channel_access(hw);
+ rtlpriv->cfg->ops->set_bw_mode(hw,
+ cfg80211_get_chandef_type(&hw->conf.chandef));
+
/*<3> Enable Interrupt */
rtlpriv->cfg->ops->enable_interrupt(hw);