net: axienet: setup mdio unconditionally

The call to axienet_mdio_setup should not depend on whether "phy-node"
pressents on the DT. Besides, since `lp->phy_node` is used if PHY is in
SGMII or 100Base-X modes, move it into the if statement. And the next patch
will remove `lp->phy_node` from driver's private structure and do an
of_node_put on it right away after use since it is not used elsewhere.

Signed-off-by: Andy Chiu <andy.chiu@sifive.com>
Reviewed-by: Greentime Hu <greentime.hu@sifive.com>
Reviewed-by: Robert Hancock <robert.hancock@calian.com>
Reviewed-by: Radhey Shyam Pandey <radhey.shyam.pandey@xilinx.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
index c7eb05e4a6bf40f20cdae60e3444f4ac83dd9771..78a991bbbcf992cda4f7c03fdf4c32c869eb7e1f 100644 (file)
--- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
+++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
@@ -2064,15 +2064,14 @@ static int axienet_probe(struct platform_device *pdev)
        if (ret)
                goto cleanup_clk;
 
-       lp->phy_node = of_parse_phandle(pdev->dev.of_node, "phy-handle", 0);
-       if (lp->phy_node) {
-               ret = axienet_mdio_setup(lp);
-               if (ret)
-                       dev_warn(&pdev->dev,
-                                "error registering MDIO bus: %d\n", ret);
-       }
+       ret = axienet_mdio_setup(lp);
+       if (ret)
+               dev_warn(&pdev->dev,
+                        "error registering MDIO bus: %d\n", ret);
+
        if (lp->phy_mode == PHY_INTERFACE_MODE_SGMII ||
            lp->phy_mode == PHY_INTERFACE_MODE_1000BASEX) {
+               lp->phy_node = of_parse_phandle(pdev->dev.of_node, "phy-handle", 0);
                if (!lp->phy_node) {
                        dev_err(&pdev->dev, "phy-handle required for 1000BaseX/SGMII\n");
                        ret = -EINVAL;