-ifupdown2 (1.2.2) unstable; urgency=medium
+ifupdown2 (3.2.0) unstable; urgency=medium
+
+ * Fix: Sonarqube issues
+ * Fix: ifquery hangs indefinitely on ^C
+ * Fix: Skipping admin down on deleted vlans
+ * Fix: Merge existing MTU into new netlink object
+ * Fix: scheduler: env variable not properly set for user commands (fixes #218)
+ * Fix: ifquery-check: vlan-protocol for dotted interfaces
+ * Fix: Down ops on vrf-slave should set the slave admin down
+ * New: Allow bond creation without slaves
+ * New: Add `--set-ring` option to ethtool
+ * New: Openvswitch : add support for fakebridge
+ * New: add support for systemd logging (--systemd)
+ * New: Process hwaddress before processing ip addresses
+ * New: Set protodown off on bond slave before bond is deleted
+ * New: Make sure bond speed and slaves (swps) speed are matching
+
+ -- Julien Fortin <jfortin@nvidia.com> Thu, 04 May 2023 23:42:00 -0700
+
+ifupdown2 (3.1.0-1) unstable; urgency=medium
+
+ * New: ifquery-check now validates admin state
+ * New: bond: bond mac should always be inherited from it's first slave
+
+ * New: macvlan/addressvirtual features:
+ - check interface name lenght and warn if len > 15
+ - sync macvlan forwarding state with lower-device
+
+ * New: vxlan features:
+ - Single vxlan device support (bridge-vlan-vni-map)
+ New attributes:
+ - vxlan-mcastgrp-map (vxlan multicast group for single-vxlan device)
+ - vxlan-vnifilter (vxlan vni filter for single-vxlan device)
+ - vxlan-remoteip-map (static HREP entries for static single vxlan dev)
+ - vxlan-tos (ToS value)
+ - vxlan-udp-csum (whether to perform checksumming or not)
+ New policy:
+ - vxlan-support-mix-dev-types: allow mix of traditional and single
+ vxlan device (default to yes)
+
+ * New: bridge features:
+ - add multi bridge support for bridge_set_static_mac_from_port=yes
+ - check if bridge mac is already inherited from a port
+ - detect VXLAN mis-config VNI "bridge-learning=on" and warn
+ - detect and warn when arp suppression is enabled but no vlan config
+ - bridge-arp-nd-suppress with ifquery --with-default if policy is set
+ - enable ipv6 on SVD brport
+ - enable forwarding on dhcp bridges (fixes: #179)
+ New attribute:
+ - bridge-vlan-vni-map (single vxlan device support)
+ New policy:
+ - bridge_always_up_dummy_brport
+
+ * New: address features:
+ - warn user if L3-SVI is configured with "ip-forward off"
+ - enable ipv6 before adding new address
+ New policies:
+ - check_l3_svi_ip_forwarding (check ip forward on l3 svi, default off)
+ - ip_blacklist: blacklist specific ip addresses
+
+ * New: vlan features:
+ - check vlan-id misconfiguration and print warning
+ New attribute:
+ - vlan-bridge-binding (if enabled link state is no longer automatically
+ transferred from the lower device)
+
+ * Fix: address: remove stale fdb entry for svi (when hwaddress is used)
+ * Fix: usercmds: Set environment just like the original ifupdown
+ * Fix: update mako template warning (python3-mako)
+ * Fix: batman_adv: fix unresolved reference
+
+ -- Julien Fortin <jfortin@nvidia.com> Mon, 05 Jul 2021 23:42:42 +0200
+
+ifupdown2 (3.0.0-1) unstable; urgency=medium
+
+ * New: python3 support
+ * New: attribute alias support
+ * New: bridge-always-up attribute
+ * New: set bridge mtu with policy default
+ * New: ES bond with "es-sys-mac" attribute
+ * New: vxlan attribute: vxlan-mcastgrp-map
+ * New: support for "veth-peer-name" attribute
+ * New: dhcp policy: dhclient_retry_on_failure
+ * New: support for marking interfaces as mgmt interfaces
+ * New: bridge-vlan-vni-map attribute (single vxlan device)
+ * New: dhcp: skipping dhcp configuration if link-down yes
+ * New: vrf-slave: keep vlan down if lower device has "link-down yes"
+ * New: vxlan: support for vxlan-svcnodeip6 and vxlan-mcastgrp6 (fixes #43)
+ * New: support for add ovs-ports-condone-regex attribute (openvswitch)
+ * Fix: dry-run exceptions
+ * Fix: bond enslavement ordering
+ * Fix: process MTU before addrgen
+ * Fix: set bridge MTU after bridge creation
+ * Fix: ifquery-running: incorrect displayed data
+ * Fix: tunnel configuration compatibility with ifupdown1
+ * Fix: start-networking script is back to handle mgmt & hotplug cases
+ * Fix: devices matching with ".{0,13}\-v" could get removed by ifreload
+ * Fix: mstpctl: check mstpctl-stp and bridge-stp and fix bridge cache update
+ * Removing python-argcomplete dependency
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Tue, 04 Aug 2020 23:42:42 +0200
+
+ifupdown2 (2.0.2-1) unstable; urgency=medium
+
+ * New: addons: ethtool: add support for "ethtool_ignore_errors" policy
+ * New: addons: dhcp: if mgmt vrf context exec dhclient in default vrf
+ * Fix: nlpacket: don't raise an exception on 24 bytes mac address (#140)
+ * Fix: IFLA_INFO_KIND: decode tunnel data
+ * Fix: XFRM for 2.x release
+ * Fix: addons.conf: remove duplicate entry for tunnel pre-up
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Wed, 04 Mar 2020 23:42:42 +0100
+
+ifupdown2 (2.0.1-1) unstable; urgency=medium
+
+ * New argv option: --nldebug to print netlink debug message
+ * New: ethtool: nics (GRO, LRO GSO, TSO, UFO, TX and RX) offload attributes
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Tue, 31 Dec 2019 15:21:06 +0100
+
+ifupdown2 (2.0.0-1) unstable; urgency=medium
+
+ * Introduction of the live netlink cache
+ * Refactoring and PEP8 fixes
+ * Install systemd ifupdown2.netowrking.service and ifup.service
+ * Addons: bond: bond-primary attributes (closes: #9)
+ * Addons: address-virtual: vrrp support
+ * Addons: address: add arp-accept option
+ * Addons: tunnel: adding "tunnel-" prefix to every attributes
+ * Loopback interface won't go down (unless link-down yes)
+ * Macvlans (address-virtual) can now be configured without ips
+ * Add support for vxlan multicast group (vxlan-mcastgrp)
+ * New sets of poliicies:
+ - bridge polcy for vxlan port: bridge-vxlan-arp-nd-suppres (ON/off)
+ - bridge policy for vxlan port: bridge_vxlan_port_learning (ON/off)
+ - bridge policy for vxlan port:
+ vxlan_bridge_igmp_snooping_enable_port_mcrouter (1/0)
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Tue, 01 Oct 2019 23:42:42 +0200
+
+ifupdown2 (1.2.8-1) unstable; urgency=medium
+
+ * New: Add policy dhcp6-duid to specify DUID type to be used for IPv6 interfaces
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Thu, 11 Jul 2019 23:42:42 +0200
+
+ifupdown2 (1.2.7-1) unstable; urgency=medium
+
+ * New: Add bridge-ports-condone-regex option (closes #117)
- * Support for new iproute2 format (bridge vlan show)
- * Pypi install: local addons modules should be loaded first
+ -- Julien Fortin <julien@cumulusnetworks.com> Tue, 09 Jul 2019 23:42:42 +0200
+
+ifupdown2 (1.2.6-1) unstable; urgency=medium
+
+ * Fix: AttributeError exception in bridge module (fixes #90)
+ * Fix: ifupdownaddons: LinkUtils fix cmd concatenation (closes: #930839)
+ * New. policymanager: merge module policy instead of overriding duplicates
+ * New: set default mtu on user defined device (via link-type)
+ * New: add support for vxlan-ttl attribute
+ * New: add support for vrrp attribute
+ * New: introduce new bridge policy:
+ "vxlan_bridge_igmp_snooping_enable_port_mcrouter"
+ * New: link-down yes will also down macvlans
+ * New: XFRM addon module
+ * New: Add policy to wait for IPv6 link local address to be available
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Sun, 23 Jun 2019 23:42:42 -1000
+
+ifupdown2 (1.2.5-1) unstable; urgency=medium
+
+ * Fix: ifupdown2 scripts: log warning on EACCES exception (Fixes #89)
+ * Fix: debian: install sysvinit script (closes: #918775)
+ * Fix: debian: postinst: remove diversion after upgrade from stretch
+ (closes: #919443)
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Mon, 21 Jan 2019 23:42:42 +8000
+
+ifupdown2 (1.2.4-1) unstable; urgency=medium
+
+ * Fix: statemanager directory path customization via ifupdown2.conf
+ (closes: #918832)
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Fri, 11 Jan 2019 23:42:42 +0000
+
+ifupdown2 (1.2.3-1) unstable; urgency=medium
+
+ * Fix: log: use stderr if syslog initialization fails (closes: #917534)
+
+ -- Julien Fortin <julien@cumulusnetworks.com> Sun, 30 Dec 2018 23:42:42 +0700
+
+ifupdown2 (1.2.2-1) unstable; urgency=medium
+
+ * New: add support for B.A.T.M.A.N. adv. attributes
+ * New: support for new iproute2 format (bridge vlan show)
+ * New: add new checks for existing device with vxlan attributes
+ * Fix: pypi install: local addons modules should be loaded first
* Fix: link-down yes on vrf slaves
* Fix: nlmanager: use strerror to format kernel error
- * Add: new checks for existing device with vxlan attributes
- * Ethtool: FEC: translate None and NotSupported values to link-fec off
+ * Fix: ethtool: FEC: translate None and NotSupported values to link-fec off
+ * Fix: man: remove non-implemented -m option (closes: #905572)
- -- Julien Fortin <julien@cumulusnetworks.com> Thu, 13 Dec 2018 23:42:42 -0800
+ -- Julien Fortin <julien@cumulusnetworks.com> Thu, 20 Dec 2018 23:42:42 +0000
ifupdown2 (1.2.1) UNRELEASED; urgency=medium
projects / mirror_ifupdown2.git / blobdiff