+Avoiding link-local addresses on tap and veth devices
+~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
+
+With IPv6 enabled by default every interface gets a MAC-derived link local
+address. However, most devices on a typical {pve} setup are connected to a
+bridge and so the bridge is the only interface which really needs one.
+
+To disable a link local address on an interface you can set the interface's
+`disable_ipv6` sysconf variable. Despite the name, this does not prevent IPv6
+traffic from passing through the interface when routing or bridging, so the
+only noticeable effect will be the removal of the link local address.
+
+The easiest method of achieving this setting for all newly started VMs is to
+set it for the `default` interface configuration and enabling it explicitly on
+the interfaces which need it. This is also the case for other settings such as
+`forwarding`, `accept_ra` or `autoconf`.
+
+Here's a possible setup:
+----
+# /etc/sysconf.d/90-ipv6.conf
+
+net.ipv6.conf.default.forwarding = 0
+net.ipv6.conf.default.proxy_ndp = 0
+net.ipv6.conf.default.autoconf = 0
+net.ipv6.conf.default.disable_ipv6 = 1
+net.ipv6.conf.default.accept_ra = 0
+
+net.ipv6.conf.lo.disable_ipv6 = 0
+----
+
+----
+# /etc/network/interfaces
+(...)
+iface vmbr0 inet6 static
+ address fc00::31
+ netmask 16
+ gateway fc00::1
+ accept_ra 0
+ pre-up echo 0 > /proc/sys/net/ipv6/conf/$IFACE/disable_ipv6
+(...)
+----
+
+
+Notes on IPv6
+-------------
+
+The firewall contains a few IPv6 specific options. One thing to note is that
+IPv6 does not use the ARP protocol anymore, and instead uses NDP (Neighbor
+Discovery Protocol) which works on IP level and thus needs IP addresses to
+succeed. For this purpose link-local addresses derived from the interface's MAC
+address are used. By default the 'NDP' option is enabled on both host and VM
+level to allow neighbor discovery (NDP) packets to be sent and received.
+
+Beside neighbor discovery NDP is also used for a couple of other things, like
+autoconfiguration and advertising routers.
+
+By default VMs are allowed to send out router solicitation messages (to query
+for a router), and to receive router advetisement packets. This allows them to
+use stateless auto configuration. On the other hand VMs cannot advertise
+themselves as routers unless the 'Allow Router Advertisement' (`radv: 1`) option
+is set.
+
+As for the link local addresses required for NDP, there's also an 'IP Filter'
+(`ipfilter: 1`) option which can be enabled which has the same effect as adding
+an `ipfilter-net*` ipset for each of the VM's network interfaces containing the
+corresponding link local addresses. (See the
+<<ipfilter-section,Standard IP set 'ipfilter-net*'>> section for details.)
+
+
+Ports used by Proxmox VE
+------------------------
+
+* Web interface: 8006
+* VNC Web console: 5900-5999
+* SPICE proxy: 3128
+* sshd (used for cluster actions): 22
+* rpcbind: 111
+* corosync multicast (if you run a cluster): 5404, 5405 UDP
+