update sources to ceph Nautilus 14.2.1

[ceph.git] / ceph / doc / rbd / iscsi-target-ansible.rst

diff --git a/ceph/doc/rbd/iscsi-target-ansible.rst b/ceph/doc/rbd/iscsi-target-ansible.rst
index f57f22bafc67cec751df986c54c2ddcc86f743f5..564c1064ab5a5d306d3df9280e681b45d5848a92 100644 (file)
--- a/ceph/doc/rbd/iscsi-target-ansible.rst
+++ b/ceph/doc/rbd/iscsi-target-ansible.rst
@@ -11,9 +11,9 @@ install, and configure the Ceph iSCSI gateway for basic operation.
 
 -  A running Ceph Luminous (12.2.x) cluster or newer
 
--  RHEL/CentOS 7.5; Linux kernel v4.17 or newer; or the `Ceph iSCSI client test kernel <https://shaman.ceph.com/repos/kernel/ceph-iscsi-test>`_
+-  Red Hat Enterprise Linux/CentOS 7.5 (or newer); Linux kernel v4.16 (or newer)
 
--  The ``ceph-iscsi-config`` package installed on all the iSCSI gateway nodes
+-  The ``ceph-iscsi`` package installed on all the iSCSI gateway nodes
 
 **Installing:**
 
@@ -160,7 +160,7 @@ On the Ansible installer node, perform the following steps.
 
    .. note::
     For more information on using the ``gwcli`` command to install and configure
-    a Ceph iSCSI gateaway, see the `Configuring the iSCSI Target using the Command Line Interface`_
+    a Ceph iSCSI gateway, see the `Configuring the iSCSI Target using the Command Line Interface`_
     section.
 
    .. important::
@@ -172,7 +172,7 @@ On the Ansible installer node, perform the following steps.
 
 **Service Management:**
 
-The ``ceph-iscsi-config`` package installs the configuration management
+The ``ceph-iscsi`` package installs the configuration management
 logic and a Systemd service called ``rbd-target-gw``. When the Systemd
 service is enabled, the ``rbd-target-gw`` will start at boot time and
 will restore the Linux IO state. The Ansible playbook disables the